1705Likes
LinkBack URL
About LinkBacks
P & p
When I was thinking of Proteus and Penelope I was thinking about something thin and small. I just wanted to make an atomizer that will smaller than the other rebuildables but at the same time to take much more liquid inside it. I manage to do that with Penelope. But because our purpose is the "small", then we can make a very small atomizer and it will still take inside what liquid other rebuildables out there can take.
So the Penelope will take 3ml of liquid and it will be at 47,5mm. Its very very small as I see it. I made a 18mm mouthpiece so the total length with the mouthpiece attached will be at 65,5mm. Proteus will be at 100mm, so in a total of 165,5mm we will have:
Venting cap like GGTS
Engraved tube with a very deep engraving this time
No spring anywhere inside Proteus (battery or button). Springs are what cause all the problems in any kind of electrical devices
Adjustable front cap so battery will always make contact even without a spring
AD control (like GGTS)
Penelope with 2ml capacity (with AD liquid control)
Separate electronic button (goes on and off anytime from the main tube so we dont throw out the whole unit if electronics fail)
Button has the following functions:
lock-unlock option
protection if we put battery in the wrong way
short cirquit protection
boost voltage from 3 to 7,4 volts
Cut current if button gets pressed more than 14 seconds
flat SS button
14500 battery
17mm total width
165,5 total length
Welcome to ECF! We are the world’s largest electronic cigarette website. Here you’ll find a world of ecig information, discussion, everything for new and old users, honest reviews, and a whole lot more!
Reply With Quote
Originally Posted by blackwater
Bookmarks