Where Do I Find Whistle-Tip Cartomizers?

[Karl the heretiK]

Pretty self-explanatory, no?

Anyone?

[rave]

I've heard that you can use 901 whistle tips on the KR808, but I haven't tried it. What I have used is the 801 whistle tip. You simply remove the white outer plug and stretch the 801 tip over the cart. After about an hour of using it I gave up though. My vapor production went waaay down.

[dogwood]

I used a VX2 before finding the KR808D-1 and I use the whitsle tips from that. They fit perfectly and needs no adjusting. You can leave the o-ring in if you want or not, it's up to you, doesn't affect it at all.

[Karl the heretiK]

I used a VX2 before finding the KR808D-1 and I use the whitsle tips from that. They fit perfectly and needs no adjusting. You can leave the o-ring in if you want or not, it's up to you, doesn't affect it at all.

And this VX2 can be found where? Is that a vaping device, or a type of cartridge or cartomizer?

I did order some fine, 901 whistle-tips from VK... and some more juice... cuz you can never have enough juice! I've been assured they'll work fine, as well, but... I like the fact you can leave the o-ring in on this VX2 you're referring too... I do believe I have to take it out for the ones I ordered...

Thanks...

[doots]

I use a 801 cart tip and they fit over end of 808 cart just fine.

[dogwood]

I got the VX2 from LiteCig. It's a J118, 3 piece unit, tip separate from the cart.

And this VX2 can be found where? Is that a vaping device, or a type of cartridge or cartomizer?

I did order some fine, 901 whistle-tips from VK... and some more juice... cuz you can never have enough juice! I've been assured they'll work fine, as well, but... I like the fact you can leave the o-ring in on this VX2 you're referring too... I do believe I have to take it out for the ones I ordered...

Thanks...

[Karl the heretiK]

Damn! I just tried the 901 whistle-tip on my 808 cart and... blech! Seems as thought the tip creates an extra amount of suction that sucks the juice out of the cart... gotta go easy on the draw with this setup...

Anyone else have this issue?

[Tanner S Hyde]

I'll venture a guess... The insert is going too far down into the carto, and the part that normally holds the stuffing is takin up alot of space. That combo makes the air passage like a straw to the carto's filler. Grab a sharp knife and trim the insert part as short as it can go and still sit in the carto firmly... I've only got one tip left for my 901 and 510's are too loose or I'd try it

[Giz's Mom]

Take an exacto knife and cut a little off the bottom of the 901 or 510 cart and they work perfectly. I also like the 801 that fits over. The soft one is what I have and I love it. I actually found the 510 worked better than the 901.

[Tanner S Hyde]

I muust have weird cartos.. the 510 AND 901 are too small to stay put