G-Tank-US-CO-OP Support Thread

[BJ43]

What about roughing the taper with sand paper.... The taper IS NOT necessary. All that was needed a to bevel the very edge on the inside........ The machine shops I deal with will cut new ss tanks for beetween 15-20 $$ .



spoken from Inspire 4g

May work, but I am not convinced the Oring is the best way to hold the tank, it is ok as a seal but like I said this atty is a Sherman tank why have such a weak connection. I knock over and drop things as I am very hands on active. If this tank connection had been screw on with an Oring seal, wow. Something putting pressure from the top makes it drop proof.

[BJ43]

You can get wave washers with fairly high compression ratings but the crown nut idea is good to, just a little more absolute re: spacing

Maybe Dan can give us the measurement from the top of the tank to the sleeve and if it is the same for both tanks.

[BJ43]

The wave washer may be the best way to go, just looked them up in SS. My problem is shipping out of the USA is very expensive for me to do trial and error testing.

http://www.hubbardspring.com/index.p...ashers-catalog

[Quigsworth]

BJ, ss wave washers are a fairly common item at any decent industrial fastener supplier, I get a lot of stuff from Fastenal, and they are international, worth a try?

Sent via carrier pigeon

[bradlyb]

Hey guys, its been hard to keep up with all of the tips and tricks being posted. Since we should be receiving them all soon is it possible to get some links to all of the new things we should purchase before we get them? (O-rings sizes, etc.)

A parts list would be awesome for us who do not have the time to read back through 2500 posts but want to fully experiment with the GTUS when it arrives.

[Mudflap]

Hey guys, its been hard to keep up with all of the tips and tricks being posted. Since we should be receiving them all soon is it possible to get some links to all of the new things we should purchase before we get them? (O-rings sizes, etc.)

A parts list would be awesome for us who do not have the time to read back through 2500 posts but want to fully experiment with the GTUS when it arrives.

G-Tank-US | All you ever needed to know…

[jorge1845]

Hey everyone, just wanted to let you guys know that i just sold my G-TANK US to Quigsworth,
not because i din't like the tank... as a matter of fact i love it. i think dan did a awesome job and i thank him very much, thank's Dan.
The thing is that i have learned to do my own and i like using them more, what i'm trying to say is that this is one hell of a device and welcome Quigsworth to the party, thank's Jorge1845

[BJ43]

Congrats Quigsworth....

[Quigsworth]

I've been checking out the Scuba mods for a while, in fact I just recently traded my Imod for a V3...but it seems I keep missing these Co-ops, and it was a real burn because the gtus really grabbed my attention, I've read the posts, seen the youtube vids, understand the issues, I think I'm up to speed...can't wait to get it...and of course mod it, lol

Sent via carrier pigeon

[Shead]

I purchased two but I'm debating on trading one I've got a V3 a mini a line a maxi and a GLV if it ever shows up