Laser Pointer mod Guide

[Sun Vaporer]

Thanks for the step by step Cisco. Among the best I've come across so far!

Contributions such as this really make for a great forum. Modders sharing info like this is truly appreciated.

Thanks again Cisco

Could not have said it any better---Thanks Cisco---------Sun

[Stormynights]

Could not have said it any better---Thanks Cisco---------Sun

Sun this needs to be sticky for the mod classes.

[Stormynights]

Cisco this is a beauty. This was exactly what our mod classes needed. Thank you.

[Cisco]

Great write-up, Nice pics too!

You could just put a drop of solder on the spring end, they seem to solder very easily.

Really like this mod. Prolly gonna try one, I have some batteries I ordered for something else and didn't use!!

Soldering the spring end works great also but you will need to cut 1-1/2 turns or so off the spring to allow room for the solder ball. I did one with out cutting the spring and the battery was so tight it put to much pressure on the pcb that the switch wouldn't work properly. The battery is already a pretty tight fit.


Cisco...

[CanyonRunner]

Soldering the spring end works great also but you will need to cut 1-1/2 turns or so off the spring to allow room for the solder ball. I did one with out cutting the spring and the battery was so tight it put to much pressure on the pcb that the switch wouldn't work properly. The battery is already a pretty tight fit.


Cisco...

Yea, I know what you mean, I have a box mod that I had to shorten the spring on too.

I was thinking to just solder the wire on the end of coil of the spring, so it can't enter the hole in the battery.

Like this:

[Cisco]

Yea, I know what you mean, I have a box mod that I had to shorten the spring on too.

I was thinking to just solder the wire on the end of coil of the spring, so it can't enter the hole in the battery.

Like this:

Thats a nice shot and a great way to do it but if the battery spins at all when threading on the end cap it could still get caught up on the spring and twist things around. Probably could sand it down and make it smooth with no sharp edges to catch on the battery holes.

It might never happen but its better to cover all the bases...

Thanks Canyon

Cisco...

[Nforcer]

How's the battery lasting on this lil mod ?
Btw Great step by step cisco

[Toro]

Thanks, Cisco.
Very nice mod!

[Cisco]

How's the battery lasting on this lil mod ?
Btw Great step by step cisco

Thanks for the comments Nforcer...

I am getting about 2 - 2-1/2 times the vape then a regular battery and its pretty consistant right up till charge time.

[Cisco]

Cisco this is a beauty. This was exactly what our mod classes needed. Thank you.

No problem stormy, anything I can do to get people modding there own...


Cisco...