my latest e-pipe mod

[imeothanasis]

yeah think you got the general idea I used a brass threaded ring that glues into the top of the bowl that a brass cap incorporating the switch screws into. the bowl had to be bored out larger to take the battery and slightly deeper.
the neck was then bored to enable the atomizer to fit inside. wires were attached to battery connector with approx 10mm of battery casing . a spring was soldered to the ground wire then this was glued into the pipe base and the spring glued into the bottom of the bowl with epoxy and the positive wire soldered to the threaded ring.
a 901 cartridge was then cut down and the pipe mouthpiece bored out to accept this .
the two halves will now go together but i also added a brass ferrule as a joining strengthener with a key to hold the mouthpiece in the correct position .
have found no need for a additional air intake hole for the attomizer it seems to get enough from around the joints

Thanks a lot Rob, Maybe you make a little little hole to the neck of the pipe, only for better air for the atomizer? Maybe more smoke?

[TxTrouble]

WOW you did a great job on that.

D

[imeothanasis]

A question Rob,

As you describe your pipe, it seems that the wires are visible. I mean if you look inside the bowl you will see on the side of it the wire from the upper ring to the battery connector. Then if you look closer, you will see and the bottom wire. Is this true? And if it is, maybe if you dig the wood inside the bowl to put in the wire and then cover the traces with ......something?

[ainako]

It looks to me as if you have 2 pipes using the penstyle atomizers, or am I mistaken? Amazing work, wish I had the skills to pull something like this off.

[rob1522]

Yes you will see the wires on the iside the negative one connects to a spring in the bottom of the bowl the positive to the top ring and trvels through a 1.5mm hole drilled from the top to the neck.

there are 2 pensyles one metal pipe with a manual switch and a cut down screwdriver clone using a janty auto switch

[Vince1]

Rob1522, Can you tell me what is the battery number you use? Is it 3.7v?

[rob1522]

battery number 16340 3.6v or 3.7v I use both

[Vince1]

Thanks Rob! Is that the same dimensions (diameter and height)as the CR123A ? do you have a cheap supplier?

[rob1522]

yeah is a CR123A battery, like a lot of us on here I get my batteries from deal extreme.

[asidrave]

excellent job.

i will most certainly make my own e-pipe now