Increasing the nicotine content of medium strength juice

[Anunnaki]

Hi, i would have posted this in the DIY e-liquid forum but haven't got the privileges yet.

Today i beefed up the 11mg medium menthol ecopure liquid i got with my EVO order from intellicig. The 11mg wasnt really giving me the throat hit and satisfaction i needed and i found myself pretty much chain vaping till my batterys run out.

I have lots of 10mg nicorette inhaler cartridges left over from previous attempts to quit so i had an idea.

I made a small hole with a safety pin in one end of the foil seal and injected a few drops of juice until the filter containing the nicotine was saturated. This took a minute or so for the liquid to be fully absorbed. I left this cartidge for 10 minutes to mascerate. Then i injected a couple of drops of my homemade 80% abv moonshine to help flush the juice out.

A hole was then made in the other end of the cartridge to let the liquid drain out. I very carefully (so as not to get any toxic nicotine into my mouth) blew through the cartridge on the end i injected into and collected the fortified juice in a suitable container. This was left for an hour or so to let the very small amount of alcohol evaporate. A few drops are impossible to blow out of the cartridge so it is slightly inefficient but now i have some decent strength juice to dip and vape with until my 36mg liquid arrives in the post next week.

The end result is very good and im not chain-vaping anymore.

note. alcohol is flammable and nicotine is toxic so be very careful trying anything like this.

[Anunnaki]

So my TW menthol 36mg arrived yesterday and im very impressed. Cant wait to try out the other TW flavours now. Anyway, based on a direct comparison of the 50:50 cut that i did on the TW menthol 36mg with VG, I reckon my method boosted the ECOpure menthol medium to around 18mg.