+ Reply to Thread
Page 1 of 2 12 LastLast
Results 1 to 10 of 16
question about Batteries in The E-Cigarette; I was wondering lf Completely draining the Batteries before charging will make a Difference? also I know how to tell ...
  1. #1
    Full Member
    Join Date
    Jun 2008
    Posts
    16

    Default question about Batteries

    I was wondering lf Completely draining the Batteries before charging will make a Difference? also I know how to tell when my battery goes into cleaning mode but how long does it blink for when I hit it too, VS when the battery dies

  2. Advertisement
  3. #2
    Senior Member ECF Veteran
    Join Date
    Oct 2008
    Location
    Mt. Baldy, CA USA
    Posts
    220

    Default

    My understanding, and I hope someone even more experienced will come along after me and make this clearer, is as follows:

    Long hit warning (after 3-5 seconds of drawing/inhaling): 5 or 6 blinks.

    Low/dead battery warning: 12 to 16 blinks immediately upon drawing/inhaling.

    Cleaning cycle: a whole mess of blinks following a drag. Unscrew your battery as quick as you can!

    As for whether it's better to charge up as soon as performance drops off a bit or better to completely exhaust the battery, I've been wondering that myself. I know some older styles of batteries (not necessarily ecig batteries) had a sort of chemical "memory" where if you charged them too soon their capacity to hold power would decrease. I don't think this is a factor anymore, but I could be wrong. I tend to swap for a fresh one and put the old one on the charger as soon as vapor production drops.

    Finally, I've heard that it's good to remove your battery from the charger as soon as possible after the light goes green.

    Again, I hope smarter people than myself follow up on this answer.
    Last edited by Dale; 11-17-2008 at 08:58 AM.

  4. Advertisement
  5. #3
    Super Member ECF Veteran
    Join Date
    Oct 2008
    Location
    Portsmouth, UK
    Posts
    323

    Default

    Battery memory isn't an issue with these sorts of batteries, it's easier to just charge them when performance drops.

  6. #4
    Full Member
    Join Date
    Oct 2008
    Location
    UK
    Posts
    66

    Default

    Oh no !

    I finished charging my 901 batt this morning and popped it in for a quick vape but the thing seems to be constantly in the ON position.

    I took it off thinking it was the cleaning cycle, but everytime I screw it back in the amiser gets so hot I struggle to take it off.

  7. #5
    Super Member ECF Veteran
    Join Date
    Oct 2008
    Location
    Portsmouth, UK
    Posts
    323

    Default

    Apparently you can sometimes remedy that by pushing a paperclip through the opening and trying to hit the switch. Either that, or a short, sharp tap on a counter might do it.

  8. #6
    Full Member
    Join Date
    Oct 2008
    Location
    UK
    Posts
    126

    Default

    Try tapping the led end of the battery on a hard surface - it sounds as though the suck switch is stuck - a few taps may release it.

  9. #7
    Full Member
    Join Date
    Oct 2008
    Location
    UK
    Posts
    66

    Default

    Genius !!!

    Thanks eyespy a few taps on my desk and it seems to have sorted it out. I was just about to chuck it as I was worried I might mistake it for another batt and ruin my atomiser !!!

    Nice one !

  10. #8
    Senior Member ECF Veteran
    Join Date
    Oct 2008
    Location
    Daytona Beach, Florida (USA)
    Posts
    180

    Default

    Batteries are funny things. Lithium-ion batteries are supposed to be without that memory problem, but as with all other batteries, it is better to fully discharge before recharging.

    The benefits are longer battery life, more consistent power, and a longer time before you need to throw them away.

    I'm not sure exactly what goes on inside a battery that would facilitate this, but the evidence suggests that it is beneficial, although not necessary, to fully drain before recharging.

  11. #9
    Senior Member
    Join Date
    Oct 2008
    Location
    Essex, England
    Posts
    224

    Default

    I think the little batteries in e-cig's are so overworked that any attempt at trying to make them last longer is a waste of time. External Power, Troggs ScrewDriver are the only way forward. I think it was Trogg who said that the batteries are never allowed to drop below a certain voltage (either 2.7v or 2.4V if I remember correctly - Trogg will put me right if I'm wrong.) That suggests to me LiPo batteries as they are the only batteries I am aware of that must not be fully discharged, and would also explain why they cost so much.

  12. #10
    Ultra Member ECF Veteran taz3cat's Avatar
    Join Date
    Nov 2008
    Location
    Port Arthur, Texas
    Posts
    1,178

    Default

    I have a battery that was "three weak puffs and your out" for a few minutes. I cleaned the juice out of the battery using a pipe cleaner and it works better I can get about five good puffs then the admoizer is too warm,

+ Reply to Thread
Page 1 of 2 12 LastLast

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

SEO by vBSEO