Page 1 of 2 12 LastLast
Results 1 to 10 of 12
Like Tree15Likes

Thread: Help, why my vaping so cold?

  1. #1
    Member
    Join Date
    Oct 2013
    Location
    Brooklyn, New York, USA
    Posts
    7

    Question Help, why my vaping so cold?

    Hi everyone,

    I'm using the eGo Twist battery with a Kanger EVOD eGo Clearomizer (bottom coil clearomizer). After some research, I've already removed the top wick of the clearomizer. Everything else is fine, but the vaping temperature.

    My draw turned out to be very cold and I couldn't feel the vape during drawing. It felt like drawing air, though it made a decent amount of smoke and good taste after drawing.

    Instead of using the eGo kit, I also filled my Greensmoke cartomizer. The draw from this cigarette-like cartomizer is warm and felt good.

    Is anything wrong with my eGo kit? Do you have any advice to make my vape warm from the eGo kit?

    Thank you very much.


    -Richard

  2. Advertisement
  3. #2
    Senior Member Verified Member Slobalt7's Avatar
    Join Date
    Oct 2013
    Location
    Murika
    Posts
    171

    Default

    You know I have the same problem with my IClear30 when I run it on my 3.7 ego, my vv ego warms it great between 5-6 volts. If I hit it constantly on the 3.7 it does warm a bit but not like my vivi or my dcts
    richard1017 likes this.

  4. Advertisement
  5. #3
    Super Member ECF Veteran Adam the Aussie's Avatar
    Join Date
    Jun 2011
    Location
    Australia
    Posts
    936

    Default

    Evods and most bottom coil clearomizers are a cool vape, try a top coil clearomizer for a warmer vape. Something like a vision vivi nova would do the job, but you won't get quite as much vapor.
    richard1017 and RedNBlack like this.

  6. #4
    Full Member ECF Veteran
    Join Date
    Mar 2013
    Location
    Condor, AB, Canada
    Posts
    144

    Default

    Hello again Richard.
    The EVODs do have a tendency to have a cooler vape as being bottom coil the vapor travels farther and therefore is cooler. If there's good vapor and flavor chances are your kit is working.
    Have you tried turning up the voltage on your battery. The Evods often come with a higher resistance head at 2.5 ohms so it takes more oomph to get the heat. You might try getting replacement heads that are 1.8 or 2.2 ohms. They heat quicker at lower voltage and should warm the vapor better.
    Hope this helps.

  7. #5
    PV Master Verified Member
    ECF Veteran
    Racehorse's Avatar
    Join Date
    Jul 2012
    Location
    Arkansas
    Posts
    6,840
    Blog Entries
    3

    Default

    you did not tell us the ohms of your delivery device.

    I suspect the greensmoke carto was a 1.8ohm and your evod coil was a 2.5ohm which is what comes inside most evods.

    You can either turn up your battery voltage (the beauty of VV) or buy lower ohm replacement coils for your evod.

    Or, find a clearo that is less "airy".


    TC's given: ~9/27/12~ ~ 11/17/2012~~04/01/2013/TC rec'd: 03/09/2013

  8. #6
    Member
    Join Date
    Oct 2013
    Location
    Brooklyn, New York, USA
    Posts
    7

    Default

    Thank you very much, Slobalt7 and Adam.
    I'm using 3.6V on my eGo. Increasing voltage doesn't help much for warm vaping.
    I'll try a top coil clearomizer.

    Thank you again.

  9. #7
    Member
    Join Date
    Oct 2013
    Location
    Brooklyn, New York, USA
    Posts
    7

    Default

    Thanks Racehorse,
    I don't know how much ohms the EVOD is. I tried to increase the eGo voltage, but that didn't help a lot, only makes terrible sound.
    Racehorse likes this.

  10. #8
    Super Member RedNBlack's Avatar
    Join Date
    Aug 2013
    Location
    NE Georgia USA
    Posts
    590

    Default

    Welcome richard1017,
    The Evods should be bottom coils, and the vape will be cooler. A top coil tank will be warmer. Increasing the voltage will not "warm" up the vape, may produce more vapor, and may make more of a "rattlesnake" sound. What is the ohms on the tank?
    richard1017 likes this.


    Vape 'em if ya got 'em.

  11. #9
    Member
    Join Date
    Oct 2013
    Location
    Brooklyn, New York, USA
    Posts
    7

    Default

    Hi RedNBlack,

    I don't know the exact ohms of my clearomizer. It is a Kanger EVOD eGo Clearomizer from myvaporstore.com, coming with the eGo-CTwist kit.

    Like abasm said, it may be around 2.5 ohms.
    Racehorse likes this.

  12. #10
    Ultra Member madqatter's Avatar
    Join Date
    Sep 2013
    Location
    Virginia
    Posts
    1,374

    Default

    Quote Originally Posted by richard1017 View Post
    I don't know how much ohms the EVOD is.
    Kanger marks the coil heads with tiny engraved numbers. Check out this photo, for example.
    richard1017 likes this.

    9/8/13 Magneto/Sig8W/MVP2
    VGan/PG-Free: ECF members with PG allergies

Page 1 of 2 12 LastLast

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •