Halo Triton: 2ml limit?
Page 1 of 2 12 LastLast
Results 1 to 10 of 15
Like Tree5Likes

Thread: Halo Triton: 2ml limit?

  1. #1
    Member
    Join Date
    Oct 2013
    Location
    NYC
    Posts
    7

    Default Halo Triton: 2ml limit?

    Hi,

    Just bought Halo Triton, and the manual is saying that liquid in the tank should not go below 2 ml. But the capacity is only 2.4 ml, so do you guys keep refilling it all the time? Basically, you need to refill it after 0.4 ml all the time? Am I missing something here?

    Thanks.

  2. #2
    PV Master ECF Veteran
    Join Date
    Oct 2012
    Location
    W England
    Posts
    4,132

    Default

    You will be missing something. We don't have Halo, but unless something is odd about their clearomizers, you can vape them to under half full before even thinking about topping up. If they have the coil in the base (as opposed to the mouth piece end) you can do 80% empty or even more.

  3. #3
    The Shortest Straw Team ECF (folding@home)
    Verified Member
    ECF Veteran
    Supporting Member
    Thrasher's Avatar
    Join Date
    Oct 2012
    Location
    Madeira beach, Fla
    Posts
    7,774

    Default

    sounds like a misprint and should probably be .2 they look like regular old kanger t2's on the website. when the liquid gets lower just remember to tip em a lot to keep the wick in the head wet.
    Fulgurant likes this.

    Semovar - Provari - Roller - Poldiac - Megatron - Nemesis


  4. #4
    PV Master ECF Veteran
    Join Date
    Oct 2012
    Location
    W England
    Posts
    4,132

    Default

    Quote Originally Posted by Thrasher View Post
    sounds like a misprint and should probably be .2 they look like regular old kanger t2's on the website. when the liquid gets lower just remember to tip em a lot to keep the wick in the head wet.
    Great!

    I used a re-hashed T2 (dual coil, totally wicked) for a while in the summer. It worked quite well down to 1/4 full or less.

    Keeping the wick(s) wet is the key. If the wick is taking up the liquid, you can get to almost empty.

  5. #5
    Ultra Member Verified Member
    Join Date
    Sep 2013
    Location
    Virginia, USA
    Posts
    1,048

    Default

    Quote Originally Posted by kobari View Post
    Hi,

    Just bought Halo Triton, and the manual is saying that liquid in the tank should not go below 2 ml. But the capacity is only 2.4 ml, so do you guys keep refilling it all the time? Basically, you need to refill it after 0.4 ml all the time? Am I missing something here?

    Thanks.
    The manual does not say, "liquid in the tank should not go below 2 ml".

    The manual says, "The Triton system will perform best when the tank contains 2ml of e-liquid or more continuously. This ensures the heating element will remain moist and extend the overall life of the coil. The Triton can certainly be used with lower e-liquid volumes in the tank, however the system then depends on the wicks to absorb liquid into the coil."

    The coil assembly is towards the top of your tank. After a long draw, simply invert the Triton to immediately get juice to the coil assembly so it's ready for the next draw without depending on wicking up from the bottom of the tank. I usually refill my tanks when they get to the 0.8ml line. I refill to about 2.3ml.
    djsvapour and Joe13 like this.

  6. #6
    Member
    Join Date
    Oct 2013
    Location
    NYC
    Posts
    7

    Default

    Quote Originally Posted by Seapup View Post
    The manual does not say, "liquid in the tank should not go below 2 ml".

    The manual says, "The Triton system will perform best when the tank contains 2ml of e-liquid or more continuously.
    Ah I see, I was a bit confused by the fact that you had to have so much e-liquid all the time.

  7. #7
    Super Member Verified Member Supergrover's Avatar
    Join Date
    Oct 2013
    Location
    Rockaway NJ
    Posts
    699

    Default

    I fill mine when they are about half empty, I have gone down lower and have not had an issue, no change in vapor or taste.
    I also have 4 xl g6 cartos, so I can have 6 flavors available
    Allthough I do like the tanks better.

    <a href="http://.....................com/"><img src="http://.....................com/banners/1382605200_20_1_USD_9_default.png" alt="" style="border:0"></a>

  8. #8
    Member
    Join Date
    Oct 2013
    Location
    NYC
    Posts
    7

    Default

    Thanks a lot for all the replies!

  9. #9
    PV Master Team ECF (folding@home)
    Verified Member
    Supporting Member
    DocTonyNYC's Avatar
    Join Date
    Oct 2013
    Location
    San Juan, Puerto Rico (and NYC)
    Posts
    5,876

    Default

    As others have pointed out, the manual recommends keeping the tanks filled above the 2ml level. They certainly work just fine with less, though. That said, I've noticed a big difference in vapor production when the tanks are fuller. For most people, I suspect, it isn't always practical to be filling constantly.
    djsvapour likes this.

  10. #10
    PV Master ECF Veteran jefsview's Avatar
    Join Date
    May 2013
    Location
    Beecher, IL, USA
    Posts
    8,276

    Default

    Tilt and swirl. As long as you keep the wicks wet close to the coils, you'll be fine.

    I usually wait until I'm down to .8ml before topping off.

    Also, if you have more questions, or just wish to hang out, HALO has their own sub-forum here: http://www.e-cigarette-forum.com/forum/halo/
    Fulgurant likes this.

Page 1 of 2 12 LastLast

Tags for this Thread

Bookmarks