How do I re prime my atomizer?
Results 1 to 4 of 4

Thread: How do I re prime my atomizer?

  1. #1
    PV Master ECF Veteran
    Join Date
    Dec 2009
    Location
    Earth
    Posts
    3,099

    Default How do I re prime my atomizer?

    I was reading that you need to re prime your atomizer, how often should I do it, and how do I do it?

  2. #2
    Moved On ECF Veteran
    Join Date
    Nov 2009
    Location
    Denver, CO, USA
    Posts
    633

    Default

    When I fill carts which is rare, I always direct drip a couple of drops on the atty. The rest of the time I'm direct dripping on the atty.. Haven't lost an atty yet.

  3. #3
    Ultra Member ECF Veteran nubee's Avatar
    Join Date
    Jun 2009
    Location
    IL, USA
    Posts
    1,496

    Default

    that's pretty much it....just 2-3 drops of juice on the bridge of the atty and let it stand for a few minutes.

  4. #4
    Senior Member Verified Member
    ECF Veteran

    Join Date
    Nov 2009
    Location
    Maryland
    Posts
    160

    Default

    After drying the atty out, I normally put 2 or 3 drops of liquid or plain PG (Propylene Glycol USP) on the mesh wick. If I'm going to use it right away, I will use a topped off cart and leave it set for about 15 minutes. Top-off with a few more drops and you're ready to go.

    Or you can just use a full cart and let it wick it's prime from the cartridge on it's own. This way takes a little longer.

    After about 4 or 5 vapes you should be good to go. I don't like to inhale the first few vapes on a fresh atomizer.

    Hope this helps.

    Edit: Your atomizers only need primed after cleaning
    Last edited by DMertz99; 12-30-2009 at 04:10 PM.

Bookmarks