A Newbie's Guide to Cleaning Your Atomizer

**KoS** · 02-26-2009, 08:23 PM

Very informative and well put. Thank you

**D_Struct** · 02-26-2009, 08:31 PM

You're all most welcome!

I am kicking around a few more topics, at the moment.

As time goes, I'll experience more there is in the gamut of e-cigarette smoking. I refuse to write about something that I haven't tried or experienced, first hand, so you won't see me pumping out information about any and everything.

When I DO find something that works, though, I'll always be willing to share it with everyone else.

I'm about to finish up my Detonator mod, so I might actually do a step-by-step instruction manual w/ pictures for constructing one of your own.

**udave** · 02-27-2009, 12:16 AM

Very nice guide. Thank you!

Originally Posted by D_Struct

Maybe I should've made it a pop-up book, instead.

**Sevenchan** · 06-27-2009, 04:40 PM

This is a fabulous tutorial!

I have one more question.

I've been playing around with my new 510. I did the "straw mod" on my cartridge, and now I notice that when I remove the cartridge, a few strands of the filling material are adhering to the "sticky-up bit" (coil?) down inside the tube of the atomizer.

Should I remove these with tweezers? Or just let them be?

**HarryM** · 01-09-2011, 05:17 PM

I use 401/2/3 atomizers. All I do to my atom is run it under very hot water from the faucet for about 30 seconds, blow it out and repeat a couple times. Dry it with an old piece of cotton t-shirt, dry fire for about 5 seconds a couple times, repeat the washing and dry firing again, then I use an Oral-B brush to gently brush the coil. I don't remember where I got this Oral-B brush. I've had it for a long time. I think it was originally used to clean braces with.