TANKS!!!! VAPERFEXION Colored TAnks at CRAZY Introductory Prices!!!!

[CDATundra]

Drew

Question, If you order these, what are you using to cut the tubes? If you do do a Video could you add that to the Video, the cutting process.
OKAY THANKS

You use a small pipe cutter that you can pick up a Lowe's or Home Depot for $5-6. The pipe cutter is small and has no handle. You just tighten the knob as you go around. HTH

[andel11]

You use a small pipe cutter that you can pick up a Lowe's or Home Depot for $5-6. The pipe cutter is small and has no handle. You just tighten the knob as you go around. HTH

Thanks Tundra

That was a fast response. Ok I will pick one up. I am sure they sell it at my nearest Ace Hardware Store. So when it tightens it won't damage the inside makings of the CE2. OK, well I will get one and find out.

Addedum to my post: Thanks Tundra but I heard from Drew and I think I will go with Pre-cut.

[andel11]

Yes I will....I have some cut (only around 20 or 25) that I will put on the site tommorow...I will hold a couple for you...Its not as easy as everyone thinks...I mean its not REALLY hard but it aint REALLY easy either!!!!

Thanks Drew

If it involves anything even just a little difficult then I rather not be bothered. OK, I will wait until tomorrow and get the Pre-Cut and hopefully I can get those extra Tanks.

[CDATundra]

Thanks Tundra

That was a fast response. Ok I will pick one up. I am sure they sell it at my nearest Ace Hardware Store. So when it tightens it won't damage the inside makings of the CE2. OK, well I will get one and find out.

I'm sure Ace will have them too. As you go around and tighten the pipe cutter, you will see that you are making a cut in the metal. You will be able to tell when you are getting close to breaking through. At that point be careful as you tighten the cutter and you should not damage the internals. Leave about 1/2 of an inch of the tubing in tact at the bottom.
Let me know how it works out for you. Good luck!

EDIT: I just noticed your update. You can't go wrong with the pre-cuts.

[andel11]

I'm sure Ace will have them too. As you go around and tighten the pipe cutter, you will see that you are making a cut in the metal. You will be able to tell when you are getting close to breaking through. At that point be careful as you tighten the cutter and you should not damage the internals. Leave about 1/2 of an inch of the tubing in tact at the bottom.
Let me know how it works out for you. Good luck!

EDIT: I just noticed your update. You can't go wrong with the pre-cuts.

Thanks Tundra

When I am ready(Drew said he will add it to a Video) I may give it a try with the price of them. I appreciate your input none the less. Thank You.

[keyzygirl]

Are they sold out?I wanted a small one in pink.bummer.

[CDATundra]

Are they sold out?I wanted a small one in pink.bummer.

Yes keyz..I think they are all gone.

[keyzygirl]

I hope more are coming soon.

[strprswpr]

My mini cracked. I put a call out to Drew. I hope there's a warranty. Only 2 days old.

[strprswpr]

Drew's the man.....A-1 in the customer service dept. Nice guy too......Wound up yapping with him for 15 minutes.