Nhaler silencer - Page 2
Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13
Like Tree1Likes

Thread: Nhaler silencer

  1. #11
    Super Member Verified Member
    ECF Veteran
    exnihilo's Avatar
    Join Date
    Jan 2013
    Location
    66502
    Posts
    836

    Default

    Drew, you the man. Thank You!

    cg
    "I carry a leaf blower hooked to fog machine when i go out. I have "'ECF for life'" stenciled on the side if it." -Me
    "I want to make an ejuice from Coconut and rUM, and call it." -Me

  2. #12
    Full Member MTFogger's Avatar
    Join Date
    Jan 2014
    Location
    North Carolina
    Posts
    134

    Default

    Ok guys heads up. Nhaler Silencer center post can be pushed in flat when installing it to the point that it will cause both negative and positives posts to touch and short out on both kamry and atm E-pioneer pipe heads. Center post are a tad bigger on most if not all pipe heads than standard 510 connections. Blew some pipe heads in the process of using them. Contacted Nhaler awhile back about them shorting out but all I got was it worked on their pipes when tested.

    Here is a fix: DO this at your own risk
    Made a rubber doughnut washer from a V2 cig condom same size as threaded side post (inside). Cut a small center hole in it. Alternative is find a very small thin flat rubber washer that will fit.
    Take a safety pin and work the center post outward (ever so gently). Pull out so the mushroom head just clears the top thread.
    Put on the washer.
    Push head back in.
    This will stop the center pin from going too far in.
    Caution pulling out the pin may cause damage or break internal wiring if pulled too far out.

    Maybe Drew can contact makers a suggest adding a fix.
    Last edited by MTFogger; 03-27-2014 at 11:05 PM.
    When it comes to a politicians mental abilities I blame the parents.

  3. #13
    Full Member SubGothius's Avatar
    Join Date
    Jan 2011
    Location
    Tucson, AZ USA
    Posts
    42

    Default

    Quote Originally Posted by MTFogger View Post
    Thanks. It would be nice and better if it was click-able to help keep it in place on the setting.
    I just got a Silencer with chrome epipe package deal, loving it so far, turns out if you screw down the Silencer to a connector base that's at least as wide as the VV dial (as is the case with this pipe), it effectively locks the dial in place where you set it; to change the voltage, just loosen the connector slightly, twist the dial, and gently retighten.
    "In theory there's no difference between theory and practice, but in practice, there is."
    -Jan L.A. van de Snepscheut

Page 2 of 2 FirstFirst 12

Bookmarks