DID Repairable Atomizer

[NC_Fog]

It's an adapter that lets you use 510 accessories on a Go-Go(personal vaporizer)battery.

Marty

[BenC7]

edit found it

[*ASH*]

Keep the screw out - the tank needs air. You will have better flavor and vapor with it out, tank needs air for mesh to wick properly. Still going to leak out wick if you lay it down flat. Either stand it up, take it off mod or lean it when not using. After tank goes down some below the holes you can lay it down, but always with airhole up.

I never take mine out because of that, Use them at home which is fine. Looking forward to Jims mini shortly.

I likethis advice and I've tried it and it's work perfect if i will setup the screw again I just made the mesh thiner so that give better vape as there is space for Air for the tank .

I think as it's just my 2'd day with the DID so I made it so good and am just enjoy it now

[MisterCombo21]

I likethis advice and I've tried it and it's work perfect if i will setup the screw again I just made the mesh thiner so that give better vape as there is space for Air for the tank .

I think as it's just my 2'd day with the DID so I made it so good and am just enjoy it now

I saw it mentioned but not sure if anyone had any luck with it... What about putting a thick and very short wick just to plug the fill hole to stop the liquid coming out too much but still allowing for some air flow? I may try this for tomorrow...

[sobero4]

I saw it mentioned but not sure if anyone had any luck with it... What about putting a thick and very short wick just to plug the fill hole to stop the liquid coming out too much but still allowing for some air flow? I may try this for tomorrow...

I tried this out this morning and it works well The wicking is much better than when the fill hole has the screw in place and vapor production is, of course, greatly improved! Thanks

[alphahot1]

I tried this out this morning and it works well The wicking is much better than when the fill hole has the screw in place and vapor production is, of course, greatly improved! Thanks

And what about the leaking? Is it possible to lay it down?

[mokaction]

U can also use the brass set screws on the top of the did to control air flow. Also if you have some try using 30 awg a1 kanthal. Easier to work with and creates a lower ohm. That way u can use a lower volt and get the same Vape as running higher ohms and higher volts. This will also increase battery life.

[mokaction]

Here is the other pic.