Wow, and I have problems not killing a 1.5ohm 306 at 3.7v
Impressive!
Wow, and I have problems not killing a 1.5ohm 306 at 3.7v
Impressive!
I have both the 1.5 ohm long and short and tend to like the long better.Not because of the lower heat or no spitting because they are both fully broke in now and don't spit.It just seems in a back to back comparison that the long gives a bit better flavor.These will take more than 3.7v as I have run mine as high as 4.5v under load with great results on some juices and they are both about 3 months old.I don't think I will be buying any more of them since I tried the COV dual coil attys and their flavor is unbelievable.I have been vaping the 1.5 at 4.5v,the 2.0 at 6v and the 3.0 at 7.4v and they are all incredible at less than $10 a pop.If you haven't tried them do so you will like them.Later
So nobody has tried an hh357 at 6volts yet?? Right now I am using Vapor Kings 510 2.2ohm attys @6volts.. Might have to take a look at the duals over at COV..
After reading through this thread I ordered a 1.5 357. I've been putting it through it's paces, and it is hands down the best atty I have tried. I'm getting a little pop, but it's not a big issue, and I think it will calm down just a bit after it is broken in a bit more. I was a Boge 2.0 carto guy, but this is a game changer.
I was only able to get the 1.5 shorty, but it's definitely not too hot for my tastes, and when I had previously used Cisco 2.0s, so this is really nice. I'm not having any issues keeping it well fed and functioning properly. I'll be getting more once they get back into stock. I would like to try the long version, though.
Bookmarks