How long does ur carto last u?

[mikamika]

Usually dry burning kills off the gunk unless you're vaping hard on sweet/dark juices and it you've been reusing the stardust for quite awhile now. Technically speaking, dry burning shouldn't burnt the wick, wicks are design to withstand very high temperature!

[JIMP-er46]

BTW, I just burnt 5 cartos, in 3 days, trying to work my tank. I can't seem to work my DCT. Gonna get juices and a carto from my supplier today, I hope it works this time.

If you're using dcc in e dct, try refilling & then topping off by filling e polyfill material too. Then, you can wait out for 5-10mins before vaping or you could cover e bottom airhole of e dcc and inhale thru' e drip tip hard w/o pressing e manual button down. After you've gotten a slight hint of flavour, then you can start vaping. Hope this helps!

[Domtine]

with practise u should be able to dry burn until the wick turn white. It will take some practice and time and maybe a few burnt out coils.

The good thing about silica is that it is able to withstand 1800deg F so most of the sticky gunk is able to be vaporized. If there still brown stuff, there's only 3 possibilities, too saturated with gunk that dry burn is only able to solidify them, silica content of the wick is less than 95% thus unable to tahan heating and cooling cycles or u're vaping at a power than burns instead of heating it. Worst case is u're using non-braided silica. These stuff melts at high temp.

For myself I use a bulli a2tm I just take the wick out and burn it using a blowtorch until the wick glows white-red and when it cools it will be good as new. Wick changing is usually done when it becomes too thin after repeated removal.