Ok so for a long time we said we would not go the Variable Voltage route as it was too advanced. But it seems to now have become an intermediate device and something we should be offering. So now we will be
Comming this week: The VOLT Spinner! allows you to adjust voltage output from 3.3v ~ 4.8v by spinning the knurled dial at the bottom. Optimun setting for ALL VOLT products is 3.6-3.8 VOLTS. However this will allow you to have more control over your vapor output. Higher Voltages will increase vapor production and increase the tempature of the vapor (CAUTION: can lead to dry hits and burnt taste with VOLT products). Lower Voltages will decrease vapor output and make the vapor cooler.
They will be available in Manual ONLY (autos are in the testing phase and may be an option in the future).
They will be available in 650, 900 and 1300 MAH.
They will be available in the VOLT colors with the smooth rubber finishes.
Threading is 100% compatible with the VOLT lineup (has inner and outer threading).
Limited quantities until March.
These will NOT have the passthrough option the X2 has....and charges will need to be purchased seperately!
(sky blue, orange, yellow, neon green, red and raspberry comming in March)
They basically look the same as the X2 without the removable bottom cap.
Price to be released day of sale*