vamo

Hello everyone, I haven't been here for a very long time so hopefully I don't break any rules I can't remember. I'm looking to buy an old used Vamo. I just need it for parts so even if the electronics don't work, it'll be fine. Dirt cheap (or free) if you don't mind just getting rid of it...

I am new to modding / advanced e-cig set-ups. My history with ecigs: For a while I have used the V2 EX set up (Kanger Tech T4 808D clearmizer tank with manual 808-d battery) then upgraded to a Kanger E-Smart System (similar to V2 EX but thicker battery and larger tank, 510 thread). I got...

So my vamo v5 is dying... I don't want another. I've gone through 3 or 4. I see vamo has come out with V6/7/8/9/10 already in the time it took me to wear this one out. My problem is that almost all of the new vamos are VW or require 18350 batteries. So what else is out there that takes 18650s...

Hello to all of you. Wish you a nice and healthy new year... I'm a vaper about 4 years... Started with eGo-W. Now it's time for me to go for a Mod. So, after my research, I ended up, expecting the following stuff: - Vamo V7 (40W) - OBS Crius RTA (V3) - Youde Kanthal A1 Wire 28ga 0.32mm - Youde...

Hey everyone! Sup fellow vapors! Okay so almost no one will know this but I made a post a little over a year ago about my upcoming purchase of a Vamo V7 and how I was worried about its reliability. I got it in the mail, it was the black chromed version. Looked beautiful. After a few weeks I'd...

Hi there, I´m into my 3rd month free from analogs and after the 'ego' phase I started to upgrade my gear and some doubts start to happen when leaping into new diy grounds. Maybe this is not a very good issue for a new members section but here it goes: I'm have a Vamo v6 pcb chip ordered by...

Vamo 2 was the first mod I've ever purchased, it served me well for a year and a half until the output started getting weaker and weaker until all it was able to produce was around 5w with a full battery. I've kept it in my scrap drawer since then. Recently my vamo 5 broke (just wont start and...

I have been having an issue where when I screw in any kind of tank, my vamo 4 reads "SHORT" and "LOW LOAD." I have made really nice coils to no avail. Someone at a store told me to just turn up the voltage - worked for a bit but then didn't. Someone on here, when I posted about it, said to...

I've had this Vamo v4 for 3 months and it's been great until yesterday. It says "short" on the display. I have tried several different coils, I have cleaned it really well. Is the pin not touching, or do I need to reset it somehow? It will give me 2 or 3 vapes and then say short until I try...

Don't know if this is the right thread... I've had this Vamo v4 for 3 months and it's been great until yesterday. It says "short" on the display. I have tried several different coils, I have cleaned it really well. Is the pin not touching, or do I need to reset it somehow? It will give me 2...

Odd question that I was going to post else where but seems I haven't the privilege/ability to do that yet... ON with my question: I've had my Sigelei Zmax for almost two years and I believe it has finally given up the ghost... Has anyone had an issue or have heard of a solution where this...

Hi everyone, I've been using the Vamo V5 that goes up to 15 and don't have particular issues with it. My father needs a backup mod and i was thinking of buying a new one and leaving the Vamo as backup. Initially i thought i'd just get another V5, but now I'm thinking of alternatives (V7 or...

Just got the Vamo V7 ant when I turn the power up above 8.00 watts it cuts out and I have to take out and put back the battery to start it again. Any ideas?

Hi everyone, I have been using a Vamo V5 and am very happy with it. I'm planning on picking up a spare to keep just in case, and I've noticed that there are versions out now up to V10. Can anyone tell me which version is considered best? And what would be the improvements in regard to the V5...

I've been struggling with my Vamo V5 after my Kayfun V4 got shortage/high ohm problem during rebuilding the coil. 1. My Vamo got extremely high temperature when I connected Kayfun V4 which had a problem with the coil. 2. I tried to stop the Vamo but it continued to heat Kayfun (coil burnt)...

So, I got a Vamo V5 primarily for use as a "traveling device". I have a Vamo V8 (or Vamo 35 depending on who you ask) that I use primarily, but it's heavy and big. I wanted something a bit more portable for taking places, so enter the V5. Really the only reason I bought this thing is because it...

I am thinking about getting a new regulated device. I have owned ego twists before, but they have broke because I am rough on my equipment. I bought a mech mod and it has held up, but now I want a tough regulated device. I was looking into getting a vamo, but I hear if you drop it, it breaks and...

Efest 18650 IMR Batteries (35A, 3.7V, 2500mAh) - On sale only $8.95! The Vapor Station - www.vaporstation.com - E cigs, E juice, Bitcoin, Bitcoins Genuine Efest batteries now in stock and on sale! We have 18350, 18500, 18650, and 26650 purple style Efest high drain batteries for the safest...

Why are my 18650 (i have 2, both different brands) batteries showing only 4v at full charge... From what ive read it should be 4.2v.. I also have a cheap charger but i dont know if this is normal

Hello, i own a number of twist batteries (ego twist 1300mah and 2 vision spinner 2's 1600mah) and 1 mod (Vamo V5). What makes the vamo so much better than these twist batteries? I mean with my nautilus tank i vape the vamo at about 11watts whereas my twist batteries anywhere from 4.3-4.8...