………………………………….Post-edit dt. December 26th, 2014………………………………….
Compilation of Important Posts
Compilation of Important Posts
Know your kayfun4√
This is a compilation of some of the important posts re: our kayfun 4, which has been posted since folks started receiving theirs circa December-8th, 2014.
Brief History of the Kayfuns:
Details at Post #696: http://www.e-cigarette-forum.com/fo...777-svo-mesto-kayfun-4-a-70.html#post14762696
K4 vs. Other Kayfuns:
K4 vs. Similar RTAs:
K4 Main Parts on Daily Use:
Details at Post #365: http://www.e-cigarette-forum.com/fo...777-svo-mesto-kayfun-4-a-37.html#post14725688
kayfun 4 Key Stats
ITEM........................STEEL TANK...........GLASS TANK........."M" TANK
Material.....................316L SS..................Borosilicate.............Polycarbonate
Height (w/out DT).......57.5mm..................57.9mm................55.5mm
Width........................22/23mm................22/23mm...............22mm
Tank capacity.............4.457534833ml.......3.943035034ml.......3.814644165ml
Insulators:.................POM-C
Bearing Rings:............PTFE
O-rings:.....................NBR 70
Compression Spring:...2.1247 Cu Be 2 silver plated)
Surface: ...................Stainless Steel Brushed
Cleaning the K4
The K4 comes in pristine condition and can be used / rebuilt straight out of the box (I did). However, many have reported that there was some speck of machine oil and/or gunk in theirs ~ thus it’d be wise to clean it up before usage. Here’s how I did it.
Stripped down to the bare minimum. 12 pieces in total. Everything had an Alcohol dip for about 15-20 minutes, then scrubbed up nice & proper with soap and a rinsed everything under lukewarm water.
After drying them I applied some vaseline into all the moving parts, especially the O-rings. This is crucial lest they get unnecessarily caught up and become a pita while disassembling later. A little bit of e-liquid could be used in lieu of vaseline but I chose to do otherwise (as a habit and my standard practice).
CAUTION:
Item numbers 1,2,3,4 needs extra care. Lookout for them lest you loose one or few in the sink. #2 & #3 must be removed b'coz they are most likely to fall out if left in the body and prone to going AWOL!
TIP:
For good measure you may also like to remove the four terminal screws as well as the AFC bolt from item #6 (total five additional pieces). Else, crank them extra tight (like I did) before you take everything to the sink.
K4 Initial / Simple Single Coil Setup:
Details and Vape Experience at Post #940: http://www.e-cigarette-forum.com/fo...777-svo-mesto-kayfun-4-a-94.html#post14786430
How is the VTF of the K4 (my expressions):
Post #1101: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-111.html#post14796961
How is the “Flavour" (w.r.t. earlier K'funs) off K4 (my impression):
a) Post #1118: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-112.html#post14798124
b) Further explained by Millah at Post #1111: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-112.html#post14797497
K4 Juice Control:
a) Details at ECF Post #1721: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-173.html#post14845711
b) BadTrainDriver explains at Post #1437: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-144.html#post14821826
K4 “First Unboxing” pics by Junny89:
View attachment 395057 View attachment 395058 View attachment 395059
Post #797: http://www.e-cigarette-forum.com/fo...777-svo-mesto-kayfun-4-a-80.html#post14772794
Some K4’s are coming with "open seal”:
View attachment 396883
a) HBcorpse’s Post #: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-158.html#post14832656
b) Found out it is Ok vide my Post #1621: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-163.html#post14834608
Error in Assembly Pic:
Snapdragon was the first to inform that the “Delrin encased SS nut” (part #10 & 11) is inversely positioned in ‘parts blowup pic”.
a) Post #925: http://www.e-cigarette-forum.com/fo...777-svo-mesto-kayfun-4-a-93.html#post14785714
b) MteK explains it at Post #1736: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-174.html#post14846512
External Parts / Accessories of the old K’fun fit the K4:
a) Details at Post #948: http://www.e-cigarette-forum.com/fo...777-svo-mesto-kayfun-4-a-95.html#post14786928
b) Further info by Evgeny131 at Post #1026: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-103.html#post14791493
K4 Problems with DNA40:
a) RickCain explains at Post #1075: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-108.html#post14795189
b) And by Freedog at Post #1286: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-129.html#post14811585
c) Also explained by Brekec88 at Post #1325: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-133.html#post14813095
d) Steam_Bern explains his build at Post #1441: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-145.html#post14822063
Dual Coils on the K4:
First “duals” by Evgeny131 at Post #1084: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-109.html#post14795981
Take on K4 with P3 Connector:
a) Post #1122 by Mtek: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-113.html#post14798690
b) Post #1324 by DougFNJ: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-133.html#post14812980
c) rcbell.N51 states at Post #1539: www.e-cigarette-forum.com/svomesto-kayfun-4/post1539
d) And Post #1936 by Rodsky77: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-194.html#post14888801
e) Further by Junny89 at Post #1937 : http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-194.html#post14889178
Aal_ finds wicking with M Tank is better than the other modes:
Post #1430: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-143.html#post14821341
Some notable K4 User Experiences:
a) RickCain’s Initial Thoughts at Post #862: http://www.e-cigarette-forum.com/fo...777-svo-mesto-kayfun-4-a-87.html#post14778217
b) Mada describes at Post #1267: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-127.html#post14810422
c) Sedge informs at Post #1442: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-145.html#post14822210
d) HBcorpse explains his experience at Post #1610: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-161.html#post14833944
e) Kaoself is not happy with the flavour (Post #1622): http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-163.html#post14834610
f) BadTrainDriver explains his build for a better flavour (Post #1640): http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-164.html#post14836411
g) Flavorpursuit offers his take on Flavor (Post #1651): http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-166.html#post14837638
h) Detailed “first impressions" by Flavourpursuit at Post #1683: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-169.html#post14843008
Coil Positioning Vs. Vape Experience:
Explained by Sedge at Post #1518: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-152.html#post14826489
The “spring” in the K4’s connectivity:
a) RickCain’s take on it at Post #1510: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-151.html#post14826193
b) Stem_Bern’s explanation at Post #1529: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-153.html#post14827379
S’n’C Cotton Yarn Build:
Details at Post #1641: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-165.html#post14836488
Double Insertion Wicks:
Details at Post #1413: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-142.html#post14820142
XC-132 over DNA40 Build by Steam_Burn:
Details at Post #1658: http://www.e-cigarette-forum.com/fo...77-svo-mesto-kayfun-4-a-166.html#post14839355
Last edited by a moderator: