Weakening 901 battery - Options? in E-Cigarette Technical; I have the TW Platinum DSE 901. One of the batteries is strong as always and the 2nd is starting ...
-
Full Member
Weakening 901 battery - Options?
I have the TW Platinum DSE 901. One of the batteries is strong as always and the 2nd is starting to produce a much weaker vape and slightly shortened battery life. Are there any tricks that can be done to bring some life back into the battery?
I'm afraid the battery is just going for a slow death, resulting in replacement.
Any tips would be greatly appreciated!
-
Buy a screwdriver, the 901 battery issues are common as far as I can tell. It may be an expensive initial investment, but the money saved on battery's in the long run is worth it to me. Also seems like my atomizers are lasting longer too.
-
Turn it into a USB pass through?
-
Full Member
ECF Veteran
I don't know how to revive these batteries, I don't know what your 901 batteries cost, but the Nebula and Vapor King batteries will work with the 901 atty, and I found them to be very good batteries, might be something for you to look at for a replacement.
When you do get tired of the constant battery buying get a magnum or SD as the battery life and replacement cost are so much better. I use the magnum at home and I use the others I have for work etc... witch I hope will extend their battery life.
-Dan
-
no matter wich supplier you get a 901 from it will be flakey as hell ..... get a janty dura .... its just amazing ... very similar to the 901 but loads better ...nothing is compatible with the 901 except the carts .... and the manual batteries are just fantastic ... bothe my TW 901 batts went lame after a week so i oonly use it with a powered passthrough .... but janty now have a dura passthrough ... so i think the 901 will be used on the pass through in the car off the cig lighter
Last edited by chief druid; 05-11-2009 at 12:14 AM.
-
You might want to try this...
Run the battery down to completely dead so the led starts flashing the instant you start drawing on your 901. Once the battery is completely discharged place it in a charge and leave it for 12 hours.
This could potentially help as LiPoly batteries can sometimes have a 'memory effect' that causes them to stop using all of the batteries capacity in the same way NiCad batteries do.
WARNING, this does NOT apply to LiIon batteries so keep your cell phones charged. 
DW
-
buy i new one
-

Originally Posted by
opusMorian
Turn it into a USB pass through?
How do one do this
-
Quite easy mate take a look at the bat modding section
-
PV Master
Verified Member
ECF Veteran
battery back from death
My rn4081 battery sudenly stop heating the atoizer, the vapor was very poor the volt output was ok the led was ok, i let drain for 2 weeks and the same so i remove the plastic end the led one, trying to see something but nothing so i put the batt. in water and vinegar and i shake it several time i did this for 15 or 20 minute, then blow genthly from the atom. contact with an air can I let it rest the night, in the morning it was like new
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules
Bookmarks