Fluval cartridge restuffing video instructions.

[grumpster]

I just put up a video showing how to re-stuff your cartridges with Fluval. Included in the video is a picture of the correct product to purchase. Fluval makes a number of different items, and most of them will not work at all. This video shows what one does work and how to use it.


YouTube - E-Cig cartridge Fluval re-stuffing 101

I hope this helps everyone.

[tlbeedy]

Great video! I'll have to try the plastic tube as well!

[Darlene7]

Thank you so much for this great video - really walks you through the process and shows how to do it all - great!!!
Thanks again
Darlene

[grumpster]

Great video! I'll have to try the plastic tube as well!

Thanks. Glad you enjoyed it. I'm going to do a video showing how to do the tube mod next. I've seen a lot of discussion on both topics, but not a lot of help in actually doing it. I don't own enough devices or try out enough juices to be competent in reviewing them, but I am good at the instructional stuff. It's the one thing I can do to return to the forums all the information I've taken from since the beginning.

Besides, this way, no one has to look at my mug.

[Cellmeister]

Nice Job Grumpter! Thanks For The Video!

Thats Like How I Do It, But I Cut My Straw A Little Shorter (Personal Preference).

~Keep Vapin~!

[Christina]

Wow! That is an outstanding instructional video. Your demonstration is crystal clear. Thank you kindly grumpster! I am anxious to give this a try and look forward to your next video.

[jtwh20]

fantastic!!! very clear and concise - Thank You!!!!

[KreeL]

You forgot to leave the air pocket at the bottom of the cart for the straw mod to work correctly. In my experience, you pull the stuffing out about a 1/4", and then cut it flush with the top.

[leaford]

Interesting. I've done a somewhat different straw mod a few times. I cut a piece of filler about 1/4 inch short, and cut a 1/4 inch section of a regular soda straw. Then I put the straw section in the bottom of the cartridge, and the foam on top, so it made a pocket under the foam, to serve as a reservoir. I didn't do it for long enough to be sure, but it seemed to make the cartridges last a bit longer. But, in the end, all the prep time didn't seem worthwhile to me. It was easier to just top off a regular cartridge a bit more often.

So, what's the advantage of the side-straw? More consistent flow rate?

[rejoice]

Very good video and you are a good instructor. Going to find me some of that material to try this. Now I know how to do it right.