USB mod with pneumatic switch

[aaa]

The PTC multifuse resistor I mentioned a hundred times before, would probably solve the 6V problem, too, as it has a current stabilizing effect on the long run. So, you could use the same modded device at 6V, with just a little more vapor produced, and still no burning of the filling material.

But never mind. It is too complicated to connect such a resistor in series with the atomiser. Forget about it. Really.

[bluewolf]

The PTC multifuse resistor I mentioned a hundred times before, would probably solve the 6V problem, too, as it has a current stabilizing effect on the long run. So, you could use the same modded device at 6V, with just a little more vapor produced, and still no burning of the filling material.

But never mind. It is too complicated to connect such a resistor in series with the atomiser. Forget about it. Really.

MF-R050-2 PTC 40A 60V Fuse Resettable MFR Bourns (10) - eBay (item 120336655680 end time Dec-19-08 07:23:48 PST)

[aaa]

Bluewolf, its quite expensive there.
I go into an electronics shop here in Budapest anytime, and buy one for 80 HUF, that equals to about 30-40 (US) cents.

Edit: Just now I see, you get 10 pieces for that 6 USD. It is OK, then.