When Blowing Out Your Atomizer

[just-a-nobody]

Whenever you blow out your atty, be sure to blow from both ends, to be sure you get most of the excess juice, and be sure to use a paper towel to blow the excess juice into.

[Scottes]

On a 510, be sure cover the bottom center hole on the battery end, and blow into the cartridge opening. This will blow out the two small air holes just above the threads.

[MrNYFC]

Make sure you wipe the brass (where the atty meets the battery) end to not get any juice in your mouth!

[alvitae]

I normally just use my 901's until they quit and pop in another. The other day I noticed it was flooded pretty good because I was trying out a few different luquids so I thought I would blow it out.

Blew both ends onto a paper towel. wiped off the battery end and it never worked again. Not sure what happened.

[nick779]

Make sure you wipe the brass (where the atty meets the battery) end to not get any juice in your mouth!

uhm yea, pg juice burns lol

[Vapaholic]

After your done blowing out the liquid, plug the atty with both fingers and watch the last remnants of residual liquid squeeze out of the breather hole. The air pressure & heat from your fingers over each side forces the liquid out. dab it with a kleenex. When nothing else comes out, you are ready to re-drip. i put 6-7 drops in. First draw is like vaping for the first time. Been using my 901 atty since sept. workhorse. Not bad for cheap Chinese technology.

[BigNaturals]

I got the intellicig EVO, and its refusing to make any smoke. some times it would work great then it quits slowly. bogus. Any ideas?

[ProfessorDaffy]

On a 510, be sure cover the bottom center hole on the battery end, and blow into the cartridge opening. This will blow out the two small air holes just above the threads.

That's why I love the 510's manual batteries, I used to be scared to blow out the cart end for fear of juice getting into the the battery. You don't have to worry about juice getting into the battery! And it's a good chance to clean the threads while your at it.

--Prof Daffy

[Turco Chips]

I tell ya - I've been vaping very, very, very, VERY heavily since I got my 510. Tonight I took a real good, close look at my atty. It looked like a caramel colored mess around the bottom under the wire mesh bridge...plus some stray threads from the wick were all bundled up at the bottom too. I blew it out for quite a while from BOTH ends - as the 510 batts have those 2 little vent holes above the threads - and then I trimmed the stray fibers making sure to not pull any of the wick out. It looks bright and shiny now...without any soaking. Me thinks that is you do this weekly you should be able to extend the life somewhat.

TC

[Turco Chips]

Just tried the atty and it's vaping like it's BRAND NEW!

<--- ME



TC