Dunking

[Metstoo]

So I finally found a filler mod that works for me. I settled on Fluval foam (similar to blue foam) and that's all I use. I cut it to fit fat on one end and narrow at the other, insert it narrow end in with tweezers into my 510 carts... and then I shove it all into the bottom, fill the cart with juice and use the tweezers to pull it out level to the edge again. With a few dunks for soaking.

When I refill I simply use the tweezers to shove it down to the bottom again, fill with juice, and then use the tweezers to sort of dunk the filler in and out a couple of times to get the juice soaked into the foam cells. Usually after I do this there is more room for adding a few more drops. Reposition the foam and I'm good to go.

No leaking, rarely flood the atty and lasts for a good while with plenty of juice. I'm a happy camper!

Lesson learned: Keep fiddling with what works and don't get discouraged! You'll find your vaping mojo!

[otter]

I'll have to get some of that Fluval, I do have trouble with the juice just sitting under the filler, I'll have to try that 'dunking', though it sounds like it could get messy?

[Metstoo]

No mess. Just use the tweezers and slowly push the foam down into the cart and draw it back out again slowly. The foam springs back into shape and draws the juice in just like a sponge.

Just don't do it too fast! THEN it's messy!