Need to buy replacement heads for Protank II... which ones?
Results 1 to 5 of 5
Like Tree1Likes
  • 1 Post By _Lee

Thread: Need to buy replacement heads for Protank II... which ones?

  1. #1
    Full Member Verified Member
    Join Date
    Oct 2013
    Location
    Lakewood, Colorado, United States
    Posts
    96

    Default Need to buy replacement heads for Protank II... which ones?

    So, it's about time for me to get a bunch of replacement heads for my protanks so I'm all set for a good while but what I'm wondering is which ones should I get? Or I mean... how many ohms? Thanks in advance.

  2. #2
    Full Member Verified Member
    Join Date
    Oct 2013
    Location
    Lakewood, Colorado, United States
    Posts
    96

    Default

    by the way... decided to post this here in the VAMO forums since that's what the tank is going on, and you guys might have vamo specific advice for me

  3. #3
    Senior Member ECF Veteran _Lee's Avatar
    Join Date
    Sep 2013
    Location
    FLA
    Posts
    278

    Default

    With a vamo, it most likely will not matter since you can adjust it. On egos, I use 1.8ohm.

    The Electronic Cigarette Super Store | myvaporstore.com has them in stock and you can order a couple of each ohm if you feel like it, to test which is best for you.
    FirebornMuse likes this.
    Good Luck.

  4. #4
    Full Member
    Join Date
    Apr 2013
    Location
    USA
    Posts
    40

    Default

    i bought mine from litecigusa. they had individuals... so i bought 3 at different ohms so i could see which one i liked best. so far im going to stick right in the middle at 2.2 for the next couple of heads. gonna rebuild after i get about 10 heads collected lol

  5. #5
    Super Member Verified Member
    ECF Veteran
    SmoKnoMoCigZ's Avatar
    Join Date
    Sep 2013
    Location
    constitution state
    Posts
    441

    Default

    i get mine from discountvapers. i have a vamo on the way but have not used one yet so can`t say for sure what ohms to buy. what i can tell you is i started out with 2.5 ohm and results were ok then switched to 1.8 and BAM kicked it up a notch. like lee said it should not matter too much with a vamo... @ 1.8 ohms set vamo at 3.7 volts. a higher ohm coil would call for slightly higher voltage. just my noobie

Tags for this Thread

Bookmarks