1Likes
LinkBack URL
About LinkBacksWell, the nu-vapor forum has realtime chat also, and a bunch of other features, so I suspect most people are going there, even though it's not strictly V4L most folks are more than happy to talk V4L with anyone heh.
Well, the nu-vapor forum has realtime chat also, and a bunch of other features, so I suspect most people are going there, even though it's not strictly V4L most folks are more than happy to talk V4L with anyone heh.
Come chat!
Hi MaryKay
I see you all over the place.
Busy Busy Busy!
Anyone feel like chatting?
Born..try again, I got bumprd off!
Anyone up for a chat?
Hi,
I need help. I just got a V4L kit and the thing doesn't work well at all. I have to suck my brains out to get anything and it makes a lot of air noise. I covered the joint with scotch tape and put one hole in it and it works better. I don't think that the cart and batt are connecting right. any advise Please?
your post probably got overlooked in this section. First thing you need to check is did you remove the plastic plug from the caromizer before you screwed it on. Next look at the label on the cartomizers, some of them had the labels applied too low and it covered the slots cut in the bottom, that restricted air flow, just trim away the lower portion of the label. Try a new cartomizer, does that one do the same thing?
On to the battery if your problem isn't solved yet, look below the threads, there are three small pinholes, make sure they are open (use a pin) and when you screw the cartomizer on the slots at the bottom will either expose or cover a pinhole, more open means a more airy draw.
Let me know how its going.
Posting Permissions
Reply With Quote
Bookmarks