lavatube...retaining its memory between battery changes?
Results 1 to 4 of 4

Thread: lavatube...retaining its memory between battery changes?

  1. #1
    Senior Member* ECF Veteran gearjunky's Avatar
    Join Date
    Dec 2012
    Location
    illinois
    Posts
    162

    Default lavatube...retaining its memory between battery changes?

    isn't my lavatube supposed to remember/retain my settings when I install a fresh battery? mine doesn't seem to do that....and also im not sure what the mode of N01 is supposed to do? when I use that mode it gives me a harsh burnt massive terrible vape....so I always use mode N02...and also I cant seem to vape above the wattage of 3.0 because it's way to harsh a vape...am I just a vape wimp or what? lol...lol...lol.

  2. #2
    Forum Supplier ECF Veteran JoeInferno's Avatar
    Join Date
    Oct 2010
    Location
    Honolulu, HI
    Posts
    958

    Default

    Here is the manual to the LTv2.5 http://www.volcanoecigs.com/media/lavatube-manaual.pdf

    yes it should store the settings you have your device set on and when you replace a drained battery it should turn back on to where you left it.

    The initial setting on your Lavatube v2.5 device will vary from Average to vRMS mode in either variable voltage or variable wattage. When in Average Voltage mode (NO1) the power going to the heating elements will be a little higher than in vRMS (NO2) mode. For this reason we recommend only advanced users set the mode to (NO1). For a smoother, more consistent vape, we recommend the device be set to (NO2) mode. For a hotter, more intense vape, we recommend setting the device in the (NO1) mode but suggest you use a lower voltage/wattage setting than normal. This will help to prevent the heating element from burning out.


    what ohm is the device you are using on the LT?
    Let the Lava Flow!
    http://www.volcanoecigs.com/

  3. #3
    Senior Member* ECF Veteran gearjunky's Avatar
    Join Date
    Dec 2012
    Location
    illinois
    Posts
    162

    Default

    so far ive been using carts and tanks sometimes too. usually the carts are showing ohms anywhere between lets say 2.2 up to 2.8....I don't think ive looked at the ohms when im vaping my t3 tanks yet. buy, yes everytime I even turn my LT off for the evening and turn it back on the next day it always sets itself back to the N01 mode so I always have to reset it...and that's not even between battery changes. im not vaping the LT solely im also vaping other gear so I have not had to even swap out batteries but a few times and I have to then again switch it manually back to mode N02....hopefully my LT is not defective...

  4. #4
    Forum Supplier ECF Veteran JoeInferno's Avatar
    Join Date
    Oct 2010
    Location
    Honolulu, HI
    Posts
    958

    Default

    thats very strange. If it keeps giving you this issue please contact our CS team and we will get you fixed up. the Lavatube is covered under a 1 year warranty.
    Let the Lava Flow!
    http://www.volcanoecigs.com/

Bookmarks