iClear 16
Thanks to @Mazinny I had a bunch of iClear16s to test.
Used a red hot sewing needle to make small hole in tank to thread probe. Made small knot as a "strain relief" to keep probe from getting pulled out.
This is at 3.9v, a couple of spaced hits, then a couple chain hits:
This was at 6w, a couple of spaced hits, then a couple chain hits:
And finally, the full data:
©2017 Mike Petro. This is an open access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
Thanks to @Mazinny I had a bunch of iClear16s to test.
- Stock dual coil 2.1 ohm
- VV tested on a Provari
- VW tested ona Vamo
- 40/40/10 PG/VG/Flavoring used, 36mgml
- Standard NIST traceable Thermocouple test bench
Used a red hot sewing needle to make small hole in tank to thread probe. Made small knot as a "strain relief" to keep probe from getting pulled out.
This is at 3.9v, a couple of spaced hits, then a couple chain hits:
This was at 6w, a couple of spaced hits, then a couple chain hits:
And finally, the full data:
©2017 Mike Petro. This is an open access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.