Sophia Temperature Protected Vertical Build Tutorial√
1. Winding the
coils:
2. Wrapping the wick:
3. Inserting the build (into ceramic cup):
NOTE: Saturate the wick a little and roll it tight against the coil before placing it into the cup.
4. Check airflow:
IMPORTANT: Before placing the cup into the base always position/reposition the 510 screw so that the air hole isn't restricted.
CAUTION: Don't try adjusting it
after the cup is inserted, else it'd rotate the cup and mangle the coil inside.
5. Setup closeup views:
6. Placing the side legs:
NOTE: Attach side legs and tuck them between the coil and the cup's walls using a needle or the like/s. This helps in wicking, especially for a TP build.
7. Vapor check:
8. The Cold Ohm read: