Here's what I got so far:
Everything all laid out.
You'll see 2 long legs.
Feed both legs thru the center hole
I took the shorter lead and pulled it tight to maintain tension and lightly wrapped it around the bit.
Take the other lead and put it thru the grommet.
Then I pull for tension and lightly wrap on the other side of the bit. Then I slide the metal post in.
Trim the leads either with a cuticle trimmer or from pull and twist method (haven't mastered this method).
Put the base in the pt2 mini and test.
Will do some dry fires to push the coil together with tweezers as needed. Then pull some cotton thru, drip a little on the cotton and attach chimney and fill tank.
Pretty basic run down.
Everything all laid out.
You'll see 2 long legs.
Feed both legs thru the center hole
I took the shorter lead and pulled it tight to maintain tension and lightly wrapped it around the bit.
Take the other lead and put it thru the grommet.
Then I pull for tension and lightly wrap on the other side of the bit. Then I slide the metal post in.
Trim the leads either with a cuticle trimmer or from pull and twist method (haven't mastered this method).
Put the base in the pt2 mini and test.
Will do some dry fires to push the coil together with tweezers as needed. Then pull some cotton thru, drip a little on the cotton and attach chimney and fill tank.
Pretty basic run down.