dwcraig1

Inside top cap (top of glass tank): 17 mm x 2 mm (softer than duro 70 but duro 70's should still work). Base (bottom of tank): 17 x 2 mm (this one's real soft also) Top of chimney: 3 mm x 1 mm Bottom of chimney: 10 mm x 1 Fill screw: 2 mm x 1

Tank top (outer) and tank/base: 18 mm x 1 mm Tank top (inner): 7.5 mm x 1.5 mm

Top Cap/Tank Top + Tank Bottom: 12 mm x 1 mm Chimney Tube: 4 mm x 1 mm Base Top: 12 mm x 1 mm Chamber Cap 8 mm x 1 mm 510 screw 2 mm x 1 mm Drip Tip 5 mm x 1.5 mm

Chimney top: 5 mm x 1.5 mm Tank sections: 18 mm x 1 mm Fill screw (if applicable) 2 mm x 1 mm

Chimney top: 5 mm x 1.5 Tank Sections: 10 mm x1 mm

Chimney 7 mm x 1 mm Coil body top 15 mm x 1 mm Coil body bottom 18 mm x 1 mm Tank sections 18 mm x 1 mm Air control ring 18 mm x 1 mm Brass 510 screw 2 mm x 1 mm The first number is I.D. followed by cross section.

TAIFUN GT O-RING SIZES 17 x 1.5 are at each place where the end of the tank seals.. 12 x 1 mm on the chamber cap. 11 x 1 mm or 12 x 1 mm under the sliding sleeve. 4 x 1 on the end of the chimney (fill line). 2 x 1 mm under the 510 screw's head. 5 x 1.5 mm goes on the drip tip Buna or Nitrile...