The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

Blog entries by Burnie

  1. Yes, but as Nubilis mentioned in a subsequent post, nic solutions keep well in the freezer, and I'm guessing if anything prohibatory occurs we'll have enough warning to stock up. And actually, unflavored nic solutions aren't bad vaping at all. And lastly, flavorings are readily available from...
  2. Sophia Temperature Protected Vertical Build Tutorial√ 1. Winding the coils: [IMG] 2. Wrapping the wick: [IMG] 3. Inserting the build (into ceramic cup): [IMG] NOTE: Saturate the wick a little and roll it tight against the coil before placing it into the cup. 4. Check airflow: [IMG]...
  3. To anyone? What is the best way to clean the Ceramic CE2 cups for the Sophia? I have just been replacing them, but I want to clean and reuses the dirty ones I have been collecting (save $$), Any Ideas? Go here and find the vid of Leo torching them... Post # 7...
  4. I have a new setup for the ΣΟΦΙΑ, for those who want to tinker some more :) I will be as detailed as possible. It is a setup with only resistance wire. It better works with kanthal or nichrome 0,20mm. First we take our wire and make our coil. We leave enough at the sides ( 20-30mm each side will...
  5. Went outside to have a vape and set my mod with dripper attached on the railing around my front porch. The thing rolled off the railing and hit the concrete right on the drip tip. Went to fire it and nothing. non on the display. Pulled the center pin to see if it was still connected and it...
  6. Sophia Vertical Coil with Rayon Step-1. Coil Prepared: [IMG] Wrapped 32AWG torched kanthal (with NR legs) over a toothpick (approx 2mm OD). Step-2. Coil Squeezed: [IMG] Removed the coil, held it between a pair of tweezers and gave it a heated squeeze. Step-3. Rayon Wrapped: [IMG] A small...
  7. Billie, putting in the new O-ring made it work perfectly. Can you give me the dimensions of all the O-rings that go into both the D-base and Slim tanks along with whether they're silicone, rubber, or whatever? :) For the D-Base the outer O-rings are 13mm x 1,5mm and the inner are 9mm x 1,5mm....