The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.
Color
Background color
Background image
Border Color
Font Type
Font Size
  1. Inside top cap (top of glass tank): 17 mm x 2 mm (softer than duro 70 but duro 70's should still work).
    Base (bottom of tank): 17 x 2 mm (this one's real soft also)
    Top of chimney: 3 mm x 1 mm
    Bottom of chimney: 10 mm x 1
    Fill screw: 2 mm x 1
  2. Tank top (outer) and tank/base: 18 mm x 1 mm
    Tank top (inner): 7.5 mm x 1.5 mm
  3. Top Cap/Tank Top + Tank Bottom: 12 mm x 1 mm
    Chimney Tube: 4 mm x 1 mm
    Base Top: 12 mm x 1 mm
    Chamber Cap 8 mm x 1 mm
    510 screw 2 mm x 1 mm
    Drip Tip 5 mm x 1.5 mm
  4. Chimney top: 5 mm x 1.5 mm
    Tank sections: 18 mm x 1 mm
    Fill screw (if applicable) 2 mm x 1 mm
  5. Chimney top: 5 mm x 1.5
    Tank Sections: 10 mm x1 mm
  6. Chimney 7 mm x 1 mm
    Coil body top 15 mm x 1 mm
    Coil body bottom 18 mm x 1 mm
    Tank sections 18 mm x 1 mm
    Air control ring 18 mm x 1 mm
    Brass 510 screw 2 mm x 1 mm

    The first number is I.D. followed by cross section.
  7. TAIFUN GT O-RING SIZES
    17 x 1.5 are at each place where the end of the tank seals..

    12 x 1 mm on the chamber cap.
    11 x 1 mm or 12 x 1 mm under the sliding sleeve.
    4 x 1 on the end of the chimney (fill line).
    2 x 1 mm under the 510 screw's head.
    5 x 1.5 mm goes on the drip tip
    Buna or Nitrile

    Here's where I buy mine:
    http://www.oringsandmore.com/
    Note: 11 x 1 mm on most, 12 x 1 mm on some (under sliding sleeve)
    I've heard that on some clones that the chimney is pressed into the tank top, most are one piece.
    [​IMG]
    52anddone likes this.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice