The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

Blog entries by dwcraig1

  1. Inside top cap (top of glass tank): 17 mm x 2 mm (softer than duro 70 but duro 70's should still work). Base (bottom of tank): 17 x 2 mm (this one's real soft also) Top of chimney: 3 mm x 1 mm Bottom of chimney: 10 mm x 1 Fill screw: 2 mm x 1
  2. Tank top (outer) and tank/base: 18 mm x 1 mm Tank top (inner): 7.5 mm x 1.5 mm
  3. Top Cap/Tank Top + Tank Bottom: 12 mm x 1 mm Chimney Tube: 4 mm x 1 mm Base Top: 12 mm x 1 mm Chamber Cap 8 mm x 1 mm 510 screw 2 mm x 1 mm Drip Tip 5 mm x 1.5 mm
  4. Chimney top: 5 mm x 1.5 mm Tank sections: 18 mm x 1 mm Fill screw (if applicable) 2 mm x 1 mm
  5. Chimney top: 5 mm x 1.5 Tank Sections: 10 mm x1 mm
  6. Chimney 7 mm x 1 mm Coil body top 15 mm x 1 mm Coil body bottom 18 mm x 1 mm Tank sections 18 mm x 1 mm Air control ring 18 mm x 1 mm Brass 510 screw 2 mm x 1 mm The first number is I.D. followed by cross section.
  7. TAIFUN GT O-RING SIZES 17 x 1.5 are at each place where the end of the tank seals.. 12 x 1 mm on the chamber cap. 11 x 1 mm or 12 x 1 mm under the sliding sleeve. 4 x 1 on the end of the chimney (fill line). 2 x 1 mm under the 510 screw's head. 5 x 1.5 mm goes on the drip tip Buna or Nitrile...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice