1. Take part in the #WeAreVapor campaign

    Dear Guest, 

    The  #WeAreVapor campaign has just launched and needs your help. This is a massive push to get vapers and vapor businesses visible, and make Congress aware of the Cole-Bishop amendment. It is being organised by the Vapor Technology Association. 

    Please take a minute of your time to take a look at the site to see how you can get involved. 

    Thanks!

    Dismiss Notice

Fogger V2 Vertical Coil and Cotton Ball Wick Part 2

Published by Schnarph in the blog Schnarph's blog. Views: 740

Measuring the length needed for the positive coil leg:
[​IMG]
Positive coil leg cut to length:
[​IMG]
Positive coil leg inserted into post (notice the wire ends halfway through the post), negative leg wrapped around paperclip:
[​IMG]
Both post screws installed, tweezers used for pushing coil down close to the deck:
[​IMG]
Beginning to install wick, making sure to get some under the top (negative) coil leg:
[​IMG]
Wick installed:
[​IMG]
6 drops of e-liquid:
[​IMG]
Wick mostly poked back inside the deck. The easier way to get the clear o-ring in place:
[​IMG]
Tiny bubble after a draw, sometimes the bubble is much bigger:
[​IMG]

This is my 4th vertical coil build on the Fogger. This time the coil came to 1.16 ohm.

IMO, it works best on a mechanical mod or using a Kick 2 at 14-15 watts.

I am new at this, please feel free to leave comments and/or suggestions.

Thank you for viewing, I hope it's helpful.
  • levisdaddy
  • Schnarph
  • levisdaddy
  • gnatx
  • levisdaddy
  • 8tone8
You need to be logged in to comment