Does anyone know if there's a kick sleeve that can be used with this? If not i guess I could pick up an NHaler Silencer.
Heh. Model numbers!
18350 and a kick is pretty useless since the kick cuts out around 3.7v which an 18350 gets to that point very fast. I think I remember read the sigelei kick doesn't have the early cut off lime the evolv but could be wrong.
The Sigelei kick clone has a cutoff of about 3-3.2. The Smoktech kick clone about the same or a little higher. Both run longer.
I saw that the crown shuts off at 3. Any idea what the puff count difference would be between an insert that shuts off at 3.5 and one that shuts off at 3. I'm pretty green to this battery side of vaping. Before this I was just using ego twists.
My Smok kick cuts off around 3.6 to 3.4.The Sigelei kick clone has a cutoff of about 3-3.2. The Smoktech kick clone about the same or a little higher. Both run longer.
Here's a photo of it with the Protank I. The Protank II should work as well.Have any of you been able to use the Kanger Protank 2 on it?
You could take the battery out to test it as performance diminishes or use it with a device that has a cutoff, such as the NHaler Silencer. NHaler also has a chrome extender that might allow for use of a kick, which has a low voltage cutoff. (I have not used these products myself.)How are you supposed to know when the battery is depleted? I'm looking into getting one of these but I've always been afraid to use mechanical mods due to the fact that I wouldn't be able to check battery voltage remaining. Any suggestions on how to do so?
Yep, here's a photo with Protank II. Source page here.Here's a photo of it with the Protank I. The Protank II should work as well.
I'm kicking my .... for not picking one up on my order last week. I've had one in & out of my cart so many times in the last few months.
If that is genuine Smok it is an insane deal!