Don't see it listed on their website.
This was a test. If enough inquiries happen, he will do more. Just email him.Don't see it listed on their website.
This was a test. If enough inquiries happen, he will do more. Just email him.
Sent from my iPhone using Tapatalk
This was a test. If enough inquiries happen, he will do more. Just email him.
Sent from my iPhone using Tapatalk
Try again. Trinitytanks@gmail.com. Tell him I sent you.Already did... no custom at this time.
Test scored an F.
Try again. Tell him I sent you.
I hope you like yours as much as I am. I run a single horizontal coil and do place it near the exterior. Just want to make sure it's not too far and you get a short. Do check it before firing with an ohms meter. Even after putting the cap on. I find that I don't have to get it out even as far as I do with my RM2's.For a Single Horizontal Coil are you placing the Coil close to the exterior of the body?
Are you also lining up the air hole in front of and to the center of the Coil.
One is coming and I have never used one before so any response for a Single Coil MTL type of person would be appreciated.
Sent from my iPad using Tapatalk
Yeah, I'm wanting to get another as they are sold out at VC. (Not sure where else they might have them....will search tomorrow). I just posted in the WTB section though. Dan, I don't know if the 510 is adjustable. Am on my way to bed but didn't want to ignore you. Hopefully it will be answered here before the forum closes or perhaps in the technical section where I saw your querie. If you don't get an answer, I'll take the one off my mod and check it out.
P.s. It's kind of fun playing with the difference size hole options. I'm surprised that I haven't lost any flavor by running both holes wide open (I'm a single coiler 1.2). Then again, I'm liking more of a DLH these days.
No adjustable 510 on the O-16...