Mine was initially tight. Had to screw it on a mod to get the cap off but it did come off. If that doesn't work might want to try soaking it in really warm water, that might soften up the o-rings, be sure to twist as you pull.
Mine was initially tight. Had to screw it on a mod to get the cap off but it did come off. If that doesn't work might want to try soaking it in really warm water, that might soften up the o-rings, be sure to twist as you pull.
Mine have loosened up bit but still tight. I usually put a thin coat of eliquid around the o-ring before puting on the cap, seems to help some. The top o-ring is ok on mine it's the bottom that's the tightest. Just remember to twist as your pulling it off or putting it on. If you just press or pull without twisting could damage the O-rings.
I actually keep a tiny bottle of straight vg handy, to lube RDA's after cleaning.
just 1 drop, then a finger slide around the o-rings so they're not going on dry...
I recommend whatever works for ya, everyone prefers something different. I use twisted 316ss, 36ga, spaced. If your not sure start out with a normal spaced coil and go from there.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.