Got the ft sxk clone today...
Thanks you for the pics. I can't wait for mine, it looks bloody gorgeous! Could you do me a favor and measure the 510 driptip/driptip platform?
Got the ft sxk clone today...
Got the ft sxk clone today... the quality is by far the best i ever received from china...
I have a couple of SXK Products. I have found them to be Very High Quality.
Does anybody have the Shenray and SXK versions, to compare?
So you call this "almost flush"? Thats got to be every bit of 3mm above the deck... There is no way possible for this deck to drain completely. This is nothing more than a dripper with a BF pin added for squonking as an afterthought!!The 510 pin is dangerously low - almost flush
that's not the end they're talking aboutSo you call this "almost flush"? Thats got to be every bit of 3mm above the deck... There is no way possible for this deck to drain completely. This is nothing more than a dripper with a BF pin added for squonking as an afterthought!!
I was hoping to answer this long ago but it took a month and a half to get my SXK Hadalys from FT. (I bought the authentic Hadaly in November along with a black and clear one-piece caps.)P.S. Owners of authentic Hadaly's: Think the accessory caps might fit the SXK?
I was hoping to answer this long ago but it took a month and a half to get my SXK Hadalys from FT. (I bought the authentic Hadaly in November along with a black and clear one-piece caps.)
The authentic caps work perfectly with the SXK. Unfortunately I'm not a fan of the one-piece caps. For me, they put my mouth a little too close to the coil. Oh well.
Finally received the FT SXK Hadaly to compare to the Shenray Hadaly
$14.90 SXK Hadaly Styled RDA Rebuildable Dripping Atomizer - stainless steel / 22mm diameter at FastTech - Worldwide Free Shipping
ShenRay Hadaly 316SS Rebuildable Dripping Atomizer with Bottom Feeding Pin - Silver
Both very good machining.
SXK has plated brass squonk pin, and post screws, ShenRay has SS...same good size squonk hole
The SXK post mounting plates are ground at more of an angle, giving less room to clamp claptons.
Single wires would be fine or flip the plates for claptons.
The air holes on the SXK cap are smaller than the ShenRay, the base airholes are the same for both.
Not sure why SXK didn't match the base size air holes.
My preference is the ShenRay, mostly because of the looser airflow.
Did you soak or wash the atty prior to using it?Am I the only one where the cap doesn't sit flush with the deck? The cap just won't rest at the deck. Maybe the o-rings cause this. After a few seconds the cap gets pushed up even more. Hereby the airflow holes from the base and the cap don't even align.
Verstuurd vanaf mijn EVA-L09 met Tapatalk