Is there a cumulative guide that details the specific o-ring/washer combinations for certain battery setups as well as the kick? I'm talking about the P+18650 (which I just got today and am LOVING btw)
Cheers! Thank you! Gonna give it a go with the Kick when I get home. For now, rocking a 0.8ohm coil in medium mode Odysseus on my P+18 with an AW IMR 18650. The rhodium contacts seem to make a considerable difference vet what I'm used to, great mod!
Does anyone know what size the washer is? I got a used one that didnt come with orings or washers and am about to grab orings from home depot since my P+18650 wont fire with an 18650 1600 mah as is(1 washer 1 thick oring).
I found the washers but not the orings. They measure thickness differently any suggestions?
Here are the Precise/PrecisePlus 16340/18350/18500/18650 Oring/washer parts kits on the website now for purchase.
Refresh the page if they don't show, they are towards the bottom of the page: Super T Manufacturing, Innovative manufacturer of electronic cigarette products.
My personal guide:
Fit o-rings until battery doesn't rattle.
fit washers until desired witch throw is achieved.
*note: start off with the smallest amount of o-rings and least amount of washers, and work your way up....
Now leave Dave alone so that he can get back to R&D!
Not trying to be an ......, but 5 min. of test fitting would get you your answer, rather than waiting for someone to reply to a thread.
I'm not going to buy every size danco oring and just throw stuff in and out. It is not a hard response.
So you don't know the danco equivalent sizes?
i can give you the #16 "thin" oring measurements though:
OD=.3/4 ID=5/8 Cross section:1/16
Most hardware stores will refer to them not in the danco numerology, but in the Standard USA sizing i have them listed in the original post, so you can order or ask for them by the numbers i have them listed as.
just got home from work, so i can now be a bit more helpful...
Thick o-ring
OD=0.75" ID=0.559" Cross section:0.1"
*measurements are from my digital caliper on the thick o-ring that came on my P+18650
washers are .03" thick
Cheers! Thank you! Gonna give it a go with the Kick when I get home. For now, rocking a 0.8ohm coil in medium mode Odysseus on my P+18 with an AW IMR 18650. The rhodium contacts seem to make a considerable difference vet what I'm used to, great mod!
What if im using panasonic gcr 2250mah button top?anybody here willing to help me out
Sent from my GT-P6200