Recent content by 6stringsNvape

  1. 6

    Captain PD270 - Watts Going In Reverse

    Hi all forum friends, I picked up a Captain PD270 mod about 2 weeks ago. Since yesterday, no matter what VW setting I have it set to, after taking a puff it reverses the wattage down to 5W. I've tried firmware updates, different batteries, new coils, different firing modes, still no luck. Is...
  2. 6

    Looking for New Mod - Need rec's

    Hey ECF, Been using an Avocado 24 w/an IPv4S for a good while, used an original Uwell Crown tank before getting into builds. Comfortable with simple/functional coil builds across a few RDA's I have, but looking for a good second setup. My other go-to right now is a Horizon Duos with a...
  3. 6

    RDA SMOK Skyhook Drip Tip

    @Mel Durham , I haven't done any real searching on adapters for the top piece of the plastic that sits under where the 18mm tip connects to. However, I ordered this from MyFreedomSmokes: Tobeco TFV8 Resin Drip Tip It definitely sits in the device much better than the stock tip, but so far...
  4. 6

    Tall 810 Threaded Drip Tip - Does It Exist Anywhere?

    Thanks Shawn, but those results show 510 drip tips. From what I read about the Skyhook, what works other than the tip that comes with it are ones that also fit the SMOK TFV8, as the diameter of the tips is larger than a 510. Am I perhaps just searching the wrong thing, or is there just not a...
  5. 6

    Tall 810 Threaded Drip Tip - Does It Exist Anywhere?

    no particular preference, just curious what options are out there. I have a SMOK Skyhook, and the delrin tip on that is so close to the tank. I bought a resin tip that sits in the device better and is slightly taller, but I was wanting to to know if something like your average 510 tip is out...
  6. 6

    Tall 810 Threaded Drip Tip - Does It Exist Anywhere?

    Hey fellow vapers! I know most 810 thread drip tips are wide bore since they're pretty sweet for cloud chasing RBA's and the like, but is there any obscure drip tip maker out there that makes a tip taller than your typical commercial ones? Would love to know if someone knows a small...
  7. 6

    IPV4S - Temp Control - Stainless Steel

    Hi all, I have an IPV4S mod with a Uwell Crown (gen 1) tank. Typically I have .25 ohm stainless steel coils for the mod, and am wanting to try temp control (or Joule mode) on the device. However, the Joule mode on the IP on has options for Ni or Ti coils, and no SS option. Is there any way of...
  8. 6

    RDA SMOK Skyhook Drip Tip

    Good idea yet again, thanks alot for your suggestions!
  9. 6

    RDA SMOK Skyhook Drip Tip

    Thanks @thetrucker With these type of wide bore drip tips, are there such things as adapters for other drip tips? Curious how that would hit with a smaller radius'd tip.
  10. 6

    RDA SMOK Skyhook Drip Tip

    Awesome, that was fast, thanks @thetrucker !
  11. 6

    RDA SMOK Skyhook Drip Tip

    Hi all, new here, looking forward to a lot of learning. Recently I picked up a SMOK Skyhook. Works wonderfully, my only qualm with it is the drip tip seems to pop off with very little horizontal force, sometimes pops off in the car, etc. The manual says it comes with a Delrin wide bore drip...