Recent content by A-C-E

Welcome from a fellow Austrian!

Furthermore thoughts on rebuildables. I also stocked up on those then - those i stocked up back then are still sitting in a box on a shelf. My vaping habits changed over the years - I stocked up MTL back then. In retrospect I should have bought a variety of devices that did not offer the...

Been there - done that. Lots of european vapers like me stocked up before the TPD hit and general uncertainty about upcoming regulations and a deeming ban threatened. Although regulations did not lead to a ban I‘m happy I stocked up for lifetime. Prices went steep compared to 2014 and...

Thank you for your input. I tried combinations screws/insulator and seem to have found one that works well so far.

Thanks, I will disassemble again in the evening and have a look at the insulator and the screw.

I've got an issue with the switch of one of my paps4. The switch is prodtruding just enough that it sometimes fires when it is not locked. Probably I made some mistake at reassembly. Disassembled and reassembled again. Still no luck. Can anyone please point me in the right direction?

New Corona V8 out. Basically a Corona with 8ml tank instead of the 4ml tank and different fill method. Upgrade kits for the old version are available also. Steampipes has issues with their shop though. Several shops in Germany have listed the atomizer and the upgradekit (some are sold out...

Issue is that the tabs on the chimney of the Coppervape are larger than on the original and on the SJMY. You can make the Steamtuners tank fit in two ways: a) sand down some nubs on the steamtuners tank (caution: not all nubs need to be equally long) b) file, sand, dremel,... the tabs on the...

Declare it as a hobby then you do not have to think about it... hobbies are costly - period. Different approach: you are currently saving, the alternative would be women and cars and THAT might ruin you..

Thanks, not for me then.

Pico is a MTL atty, isnt't it?

I have now tested the Steamtuners Tank with SJMY DC Clone. It fits but is does not seal completely when LC is closed. Not a huge issue if wicked properly and on the device. It seals well enough to refill without leaking but not to remove the tank section with liquid in the tank from the deck!

@TheotherSteveS Heron V3 is not out yet. Perseas states explicitely and clearly that Heron V3 (if ever released) will not be usable with filler material --> see Vendor Forum. Spheroid V4 might be able to use with filler material but that would mean using it without the provided cap leaving a...

Izi clone has slightly misaligned airholes and a tad smaller ones too, something to consider when testing the clone. Your issues with rapid changing temperature can be adressed in various ways. 1. Topcoiler (only a solution if kept upright) 2. Top airflow (like OBS Engine <-NOT MTL!) 3. Filler...

Got Steamtuners Tank for the Hussar today. I can confirm it does not fit the Coppervape clone. Haven't tried on the SJMY clone yet.