Recent content by Benjamin89

Thanks

After May 12th 2020 when most vape products will become illegal, does anyone think fasttech.com will still ship to us? I have somewhat of a stash mechs rdas rtas etc im just curious. If its a dumb question im sorry

Thank you all for your responses

Due to the flavor ban that might eventually affect the whole country and the upcoming pmta deadline that will make it a challenge for companies to release any products at all, is it possible that vape gear will disappear. There is the diy option for juice so im more concerned about hardware. Any...

Could also be if youre using juice thats gunking up the coils quickly preventing it from wicking properly thus producing poop taste like sweet candy dessert flavors tend to gunk them up fast

Its regulated. Works fine its just that i noticed this build with this wire comes out off by quite a bit whenever i try to make it. Never experienced that with the kanthal. The app im using is telling me 6 wraps using a 3/32 bit and 26g nichrome80. Im trying to be less than .08 ohms off if i can

Im trying to make a .5 coil using 26g wire. I just started building about ago so im fairly new to all this. Ive worked with kanthal 26g 24g and 22g single and dual coils with a surprising amount of ease. But for some reason ive been struggling to arrive at the right resistances with the...

Decided to flirt with rebuilding since ive been vaping a while and it looks like there are some huge benefits from it. Yesterday i removed the premade ssocc from my toptank and put the rba section in. I immediately noticed that the atomizer all of sudden was difficult to screw into my mod and...

U know what i looked them up and they have have holes cut into them as i expected to match up where the vent holes on the mod are

I got this mod yesterday. It works very well and is very good quality considering how inexpensive it was. It is the smoant battlestar mini 80w. It takes a single 18650. I don't like to be nit picky about things however I guess I am about vape mods because I depend on them almost as much as I...

Does scratching on the negative (flat) side of an 18650 effect its ability over time to be recognized by a mod or a charger? Or is it purely superficial? I ask because lately ive been using party ribbon to pull my batteries out of my mod because its quicker and easier but i noticed because of...

Yes. Im sorry for leaving u all hanging 4 so long. After about 15 minutes in the freezer, i threw a rag on the tank and took pliers too it a second time and off it came. Thanks for all of the feedback.

Ive been using a piece of ribbon to remove my batteries from my kbox mini as oppsed to using my finger nails in the past because i found that method would always leave marks in the positive end of the battery. Recently i got a new set of batteries and continues using the ribbon under the battery...

Aspire Zelos 50W Starter Kit

That was autocorrect. Just noticed original posting lmao wow