Recent content by Carnage9270

I wasn't a big fan of the tight draw so I drilled out the center airflow to 1.2mm and also removed the oring from the top cap to eliminate flooding. Been my ADV for months now. Use the extended tank at home (little taller).

Not at all, their machining is pretty good. Well, good enough not to seep any juice anyways.

I don't vape "non-flavored" per se as I use around 5% koolada in a 50/50 mix at around 9mg. Just gives a little extra throat hit and a slight cooling sensation. Goes well with the sweetness of the VG. I've pretty much gone to my berserker and the evolve 75c with the new replay feature. Not sure...

Loose (anything) can cause the popping effect. My cotton is always tight enough that I have to hold one end of the coil with a fingernail to keep it from bending away from the airhole. Wicks great with almost no sound other than the airflow.

I've never put it back together without the bottom oring, but can imagine how much juice leaks when you do. It would be crisis mode type of leaking.

It's a link to a very trusted reviewer who is also a member here. Just getting rediculous to me is all. I see it all over the place on these forums anymore. It's bad enough when you have a popular thread on here that it's the same 10 people posting for over 30 pages, but then to start removing...

Are we really at the point where we are removing the links to reviews on a site where people give reviews and opinions? This place is getting bad...

It's literally printed on the screw itself :P

I got a Le Concorde clone a while back...amazing. I can't find anything that can keep up. Although this little gem is very good.

Yeah, pop is not enough wicking (tight through the coil) or way too much power...which I think would be noticed really fast. :)

The airflow doesn't seal completely. There's orings in there creating a gap etc. Would take some really tight tolerances to kill that. Then the price goes up.

Been running mine without the oring in the top cap. No leaking issues whatsoever. Fixes the filling pressure issue for me.

Anyone else notice in the video above, when he tightened up the 510 pin the juice holes don't line up to the sides where the cotton would be...:)

I have a feeling we'll have to choke that chamber down with quite a bit of cotton. Airflow should be nice and adjustable. But the open chamber could cause some issues. Fluff that cotton! haha

Asian sites have it for preorder until the 27th. That should give you an idea of when it will be released. Then it will take some time for it to arrive in the U.S.