Recent content by DavidTop

Help please. I am looking for Egrip Light in a smooth finish in Black and Burgandy. I already have some in the Wrinkle finish. For some reason the Light has made it to only a few US sites and then only in the Wrinkle finish.

Does anyone know how to do a hard reset on the AIO. I went to bed last night and took one final toot on mine. When I woke up this morning it was all wonky and wasn't vaping. I tried to adjust it and hitting the down button ran it all the way to 1.0. I managed to get the temp back up but the down...

That's how it should work. The Clapton is Kanthal so yes it automatically switches to Power without asking. Try your Egrip with one of the SS coils. Since SS works in both Power and TC will it ask for a prompt? I don't know since I've just been using Clapton coils.

The smaller capacity is for the EU market where tanks have a maximum capacity under their new regs.

WHY AREN'T UPDATES AVAILABLE ON MAC PLATFORM!!!!!! Sorry for yelling but Mac discrimination in this day and age? If Joyetech can do it why not Aspire.

Call me crazy, but I think the tank attaches from the side! Some sites list a separate Nebox tank.

Did That. I also swapped bases. Nada

It looks like my original egrip has some kind of short in it. When I try to vape it the light on the switch just does fast blinking. When I try a recharge the light just keeps blinking so I'm not even sure if it's charging. Does anyone have any ideas? Can I even send it in to Joyetech? I love...

I can't answer about the button ring, you'll have to go by taste. As for the blinking it happened to me. It happened for 2 reasons. First it happens when there is no base screwed in, guess it's a safety measure. That is not your problem. The other way it happened was when part of the oring on...

Did you lose the button cover or the button itself. I popped it of by dropping it and just stuck it back on and it came off at some point again but the button itself (clear plastic underneath the cover) still works. If thats the case don't worry. If you lost the actual button and the ring(?)...

I put the RBA in the 510 adapter and squeezed them together on a VaporShark and then rewicked. I could see that the coils were tighter than before. The cotton was rather loose but it seems to wick OK. I vaped on it for at least 10 hours without a problem other than a small amount of condensation...

I tightened up the coils and reworked the RBA and it still popped for a while but not nearly as bad as before and then stopped so one problem solved. I'm also getting much better taste. Another problem that came up is that today and yesterday after I came home from work the grip tank had a...

I got an RBA setup yesterday and am impressed, this is my first experience with an RBA. One thing I've noticed is that it pops when I press the firing button. It only happens once and if I take another vape within a short time it does't pop. Along with the pop some moisture is expelled through...

I know this is a stupid question but... I have an Erip without the numbers on the scale, only 20. so will turning to the right (so it would be .20) go to 8 or count down to 19. I really can't tell much of a difference so could it be defective - I dunno. I know its stupid but I swear there was...

Bump bump!