Recent content by eMado

Steel Intake with Black cap and Vandy Vape Delrin 810 Drip Tip :)

Update: This time I use same amount of cotton (Muji cotton pad) that I used before for every 3mm coils, but didn't combed out the cotton much, and filled cotton hole very compressed, with a long tails (not touching the bottom). I use max VG liquid, and this time I have no issue at all. No juice...

Hi there, Finally, I received Wotofo Serpent Elevate today. First of all, IMO, flavour is very RDA like. To compare it to Intake, I insert same coil in it and test with same liquid, flavour is very very good. (3x28ga Kanthal A1 twisted - ID 3 - 5 Wraps 0.42Ohm) Now my problem with wicking. In...

Haha. I drinked lot of juice too, after that drinking it work well. But this process repeated after filling tank again. I must change my wicking and put more cotton there.

I got my first Intake (first because I'm gonna buy another :)), I love it's airflow. Here is photo of Intake with 810 and 510 drip tip :

Thanks, It seems like a wide bore 510 drip tip, I'm I right?

Hey, Is there anyone use 510 drip tip on Intake? I want to see how it looks like. Regular size 510 driptips like :

Wow, thanks man :thumbs::thumbs::thumbs:

Like I said: "Every time when I have 2 same toy, I will modified (or damage) one of them :) Yeah, it’s typical me :) Now I have 2 Siren V2, so let’s do it."

And you was right, It wasn't easy even with compressed air tools.

Hey, I added a WARNING to the post. After inspecting inside the cylinder (with spot light and magnifying glass) I found chips inside it. I wash it again and after blowing inside to remove water, placed it under the hot sun for hours to make it dry. Now I using blower again and manage to remove...

You done it all now? Wow dude you are quick ;) At first I drilled center hole too, and vape it for on tank, honestly I didn't notice any change After using this 4 whole for a day, I wish I used 1.8mm and 1.5mm bit for 3 hole, I think that setup give me better option to choose. I didn't have...

;) After TFV8-BigBaby > Serpent SMM > Themis ... It's not airy to me at all :lol: By the way "Themis" was very very bad choice for me.

And I modified Siren air flow by increasing it's air holes :) It was fun, check my thread Let’s Increase The Air Flow of Siren 2 (Drilling...)

By unscrewing both 510 pin and connector screw you can easily clean up AFC section.