Recent content by P3ST1L3NC3

google metal madness vapors. they are the makers and sellers of the DID. I own 2 DID's and they are great.

sooo, i stopped reading this thread about 200 pages ago. without going back and reading every single post, where and when can these new BD13 wicks be purchased? anyone care to inform me? thanks!

hoping to get in on this run. thanks for the updates drew.

evolv emailed me back. they said they would send me two replacement DNA20 boards for free!! hopefully these boards are from a different lot or something. fantastic customer service. i honestly thought that i was just out 100+$ i may give these guys another chance after all. also, to help...

email sent to evolv. im so fed up with the DNA20, that i dont care if they send me 100 free boards. i just dont care to mess with them anymore. after all the anticipation and waiting for 7-10 days for the board to get here, then building everything, just to be disappointed....twice... im done...

yeah, im out over 100$ for nothing.....

so i got my second DNA20 board today. Got everything assembled, popped the battery into the battery holder, and the screen lit up. tried the up / down buttons, didn't work. tried the fire button, and it fired my DID. then looked back at the screen, and watched it go dimmer then brighter, then...

ive got a digital weller at home. the pace belongs to work! i could never justify the cost of a pace for home use. sure is nice though!

ive got a modders connector from avid on my 26650 tube. the center post is nice and hollow (not all the way through if memory serves me) but the hole in the bottom of the center post has plenty of depth to put a wire in and then fill the hole with solder. for the ground, i used a terminal lug...

thanks bapgood. im waiting for my second board to show up. takes forever to get stuff to bagram. after soldering the battery leads to the 1st DNA20 board (battery removed from battery holder) the board quit working, wouldn't power up (after putting battery back into battery holder). i...

does the onboard fire switch have to be cut off? will an external or remote fire switch still fire the DNA20 board if you leave the onboard switch intact?

tried something new. seems to be working for me. i took a wick i made that had a large head on it, then disassembled my DID, put the wick in the wick hole, then wrapped some SS mesh around the part of the ceramic wick that goes in the tank. (dunno if this will help anything, but was worth...

finally got my petsmart stones in. got a few nice wicks shaped, but noticed a few things. even after torching the wire, it was still difficult to wrap a tight coil with the wick out of the DID (30GA Kanthal). This lead to glowing wires and dry hits. I carefully wrapped a coil with the wick in...

checkout the ones i posted at the top of page 52

Retired Army, in Bagram (BAF) Afghanistan (Contractor). If any of you guys are in BAF and need supplies, shoot me a PM. Ive been here for 3 years and have a good sized stash.