Recent content by ukeman

I just got into replaceable coil vaping with GeekVape M100 and Z Nano 2 atomizer kit deal. Love the convenience and actually the vape is better in vapor and flavor than my diy rdta single coil builds (Ammit rdta). But the silcone (?) oring that has to fit on bottom side of bubble glass tank...

Changing coil everyday is good practice but unacceptable; its easier to roll a cigarette than recoil. Some sweeter juices burn faster and gunk up the coil... the other factor is heat it can burn the coil in the middle and you can see the charring on each end of the coil. Try to find the most...

My problem has to be the wicking... Im used to speedy setup so i took a lot of care to get the wick kosher and don't have the flooding problem. I don't know if its because the wick was too thick and choking or too thin, but it seems to work with it just right. Overall i need a system like this...

Not at all; but I do raise the temp/wattage as the coil gets broken in.

Love the Ammit mtl: why: i use only single coil mtl - the Savour is out of stock on FT and the AMmit is better imo; I got 2. - - I love Doggie Style but i QUIT it ( I have 3) because they're too damn much hassle to recoil. so tiny and the screws don't grab unless you use 28 or thinner and even...

Just haven't been keeping track. Once I get my quiver set up its not a priority. Until, well, its been a year since my purchasing my last 2 VS DNA 250's (one repaired -VS has a good system ) and now the other needs it. My 2 LavaBox DNA 200's (bought a couple yrs ago) have been repaired and...

I am ordering a Diagnose and Repair service from Vapor Shark and to my surprise, noticed they have no DNA VS stock. I bought these early 2017 and haven't kept up. I like basic TC as simple as possible, and like Evlov's reputation. I still have 2 Lava Box DNA200's and love the form factor, but...

I have a few Doggies from FT but not sure which brand... one didnt come with d/t. Do you change out the washer at the base where it meets the bottom of the tank? I wonder if that has anything to do with unevenness when I screw the tank on the base. Anyway I have to be very careful to thread it...

I have a few DoggyStyles going and have love/hate relationship with them but for now they are my favorite RDTA waiting for the Savour from 3cvape on FT to see if they are an improvement. I do a 2.5mm contact or spaced 28g SS at anywhere from .50 to .68 Ohms at 400 to 470F. Im sure you've all...

Ive been using mods with DNA chip with the batts proprietary installed but still have my good charger, and use flashlights with rechargeable 18650s. The thing is, and pardon me for asking OT, its been many years since ordering my high drain 18650s, which I used in my older mods, and I find that...

I am dyslexic COD ADDHD manic depressive whatever; I've gotten stuff and don't even remember getting it, how to use it, etc etc... I stopped vaping a year or two ago and boxed up a ton of top shelf gear including an unused Yihi 2 or $300 TC mod (which I refused to learn how to use; stuck with...

How many flavors do you vape?

I've been using DoggieStyle for months now and today for the life of me I couldn't trap one of the wires! Maybe 10 tries... I finally took an extra screw that came with it and replaced the one I was struggling with and having tried all angles and gyrations in the previous attempts nailed it on...

Yes the Berserker is pretty darn cool. My second tends to leak when I fill and found the post about turning it upside down and blowing to stop that... it is stingy on juices and I've found it needs a little persuading to get enough juice to the wick in between full vapes, but it definitely is a...

Ok dumb question: why dry burn in the first place? Is it to clean a used coil? To burn off oils or whatnot on the wire to begin with? Or initially to get it or make sure its firing without hot spots? To crimp the contact micro coil? I use SS 316 always and with TC... I use spaced when I have...