Recent content by XCamel_Smkr

Prefer DTL, but can go either way... Like the looks of the Ares 2, plus it's re-buildable

... --Never leave home without your peril sensitive sunglasses and your towel

Lemo --Never leave home without your peril sensitive sunglasses and your towel

... --Never leave home without your peril sensitive sunglasses and your towel

It only locks, no power off. Remove batteries if you want it all the way off... Sent from my SM-T330NU using Tapatalk

I'm in for one Sent from my SM-T330NU using Tapatalk

I'm in for one --Never leave home without your towel and peril sensitive sunglasses

Needle nose pliers with narrow tips, unbend a thick large paperclip, small scissors, you can be creative... Put in freezer for about 10 minutes and use above to try to remove the cap. This is assuming there is not battery in it...If there is, spanner is the way to go --Never leave home...

I'm in for one --Never leave home without your Peril Sensitive Sunglasses and your Towel.

Ok, I'm in for a shot --Never leave home without your Peril Sensitive Sunglasses and your Towel.

If I remember for efest batts: V1 = Flat Top V2 = Button Top

It regulates down. It can't go over it's rated specs... I have one and can tell after a point it's not increasing voltage or wattage anymore....

If they are the spring buttons, replace the springs. Somewhere your button is causing resistance which is why they are getting hot. I've read many times, for whatever reason, it is the button spring...

Hybrid refers to the mech, not rda. "Standard" mech has a center pin between the atty (or rda/rta) and the battery. "Hybrid" mech there is no pin. The atty sits directly on the battery. That is why they need more care and time to learn. They are very easy to short if your not careful.

As you first mech let me leave you with this from an Apollo clone owner: I use flat tops. Seem to work best for me, and my othet mods. Check the top cap for that insulator. Make sure, really sure, the center pin in your atty is sticking out far enough before screwing it on the mod...