So my Smowell 50W mini mod is junk. I've contacted them and they say I have to go threw seller; seller says ship it back for replace or refund but I could buy another for the cost of shipping so I'm thinking about turning it into a mech mod.
For anybody wondering the screen glitched out then all black but I was still able to use it. After that it autofired and burnt out a occ coil and aperently the board in it. I tried a bunch of stuff but no sign of life.
This little mod was perfect size for me at work.
Here is what I have
I've taken measurements and come up with a basic setup that should easily fit in place of the old chip. (I realized after uploading I forgot to put a resistor on the MOSFET)
Or if it will fit (think it will but would be tight fit) with a charging board.
I would most likely epoxy the bottom buttons in place.
Any input welcome. I'm planning to order parts soon.
For anybody wondering the screen glitched out then all black but I was still able to use it. After that it autofired and burnt out a occ coil and aperently the board in it. I tried a bunch of stuff but no sign of life.
This little mod was perfect size for me at work.
Here is what I have
I've taken measurements and come up with a basic setup that should easily fit in place of the old chip. (I realized after uploading I forgot to put a resistor on the MOSFET)
Or if it will fit (think it will but would be tight fit) with a charging board.
I would most likely epoxy the bottom buttons in place.
Any input welcome. I'm planning to order parts soon.